Having problems with your 1992 Toyota Camry V6 ?

2005 toyota camry v6 3000 four cam24 ignition coil firing order

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1992 Toyota Camry V6

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2005 toyota camry v6 3000 four cam24 ignition coil firing order


... 1992 Toyota Camry V6

Toyota I am trying to find out which wires go where. I know that the firing order is 1-3-4-2, but I don't understand the coil packs. The diagram that I have is confusing. It shows that the coil packs are listed as from front to back 1-2, 3-4. If this is the case, then why is the firing order 1-3-4-2? This is a 1999 Toyota Tacoma regular cab pick up 2.4ltr 2 WD. Any help will be greatly appreciated.


Coil pack connection is physical: Coil 1 to Cylinder 1, 2->2, etc.I am not sure if this is your question, but firing order matches spark to TDC (top dead center) on the power stroke. The design of the crankshaft determines this. ... Cars & Trucks

2005 Toyota Camry v6 3000 four cam24 replaced sparkplugs and ignition coils but starts and then dies


Do you have a steady spark?Check the fuel pressure, meybe you have a bad fuel pump ... 1992 Toyota Camry V6

How to change out ignition coils? Pictures included. I need to know what the cylinder firing order is and the number locations for the ignition coils 1 thru 6. I have a misfire code on my #1 cylinder which is in need of a plug and ignition coil.


... 2000 Lexus RX 300

Obd error code p1315 on 02 toyota camry LE 4cylinder 2.4 liter "ignition coil primary feedback circuit" is the code definition. replaced ignition coil in no 1 cylinder after getting the code "misfire in cylinder 1 and now getting above listed code p1315


P1315 is a misfire in bank 4. P1315 Igniter Circuit Fault (Bank #4) . If that is the case you will need to replace the #4 coil, which is the one closest to the drivers side. I also would advise using original fact ... 2002 Toyota Camry

Ignition firing order toyota camry 1999 4 cyl


... Toyota Cars & Trucks

Toyota camry 96 coil pack firing order - 1991 Toyota Camry


... 1991 Toyota Camry

2007 Toyota Rav 4 ignition coil. Is the ignition coil or the ecm responsible for the firing order?


The crankshaft sensor and the camshaft sensor tell the ECM what to do and when the injectors/spark to occur. ... 2007 Toyota RAV4

What is the primary and secondary ignition code po356 F mean OBD read out states code PO 356 F primary and secondary ignition is this mean a bad coil pak ? and is the firing order for this truck using letters to mean the plug order such as cylinder example 1,2,3,4,5,6,7,8 are the cylinders described now with letters and if so which side is F on and please explain


... Ford F-150

3.8L (VIN C, 1, L and K) Engines Firing Order: 1-6-5-4-3-2 Distributorless Ignition System what is the order of connecting the wires on the coil?


3.8L (VIN C, 1, L and K) Engines Firing Order: 1-6-5-4-3-2 Distributorless Ignition System\015\012\015\012 ... 1988 Buick LeSabre

Coil pack fire order 98 toyota camery - 1998 Toyota Camry


... 1998 Toyota Camry

Need some help. I did change just one wire at a time but somehow messed up on the last two as the ignition system misfire code is coming since and the car doesn't feel like it has the normal power. The engine is a 1zzfe for a 98 Corolla and the firing order is supposed to be 1342... If I were facing the car with the hood open the spark plugs in their tubes go 1 2 3 4 respectively. I wanted to know what the order of connecting the wires is - there are, what looks like two pairs of coil


I would pull the spark plugs and check for any cracks or carbon tracking, or a possible weak spark from the coil. ... Toyota Corolla

Ignition coil Our 2002 Lanos is pulling a misfire code. I have discovered that the ignition coil is firing 1 and 4 cylinders. Cylinders 2 and 3 seem to have a very weak spark output. 1 and 4 are on the same half of coil, and work fine. 2 and 3 are on other half of coil. I have changed the ignition wires twice to check for bad wires. Problem seems to be coil. I am buying one on Ebay, good price. Hope this resolves issue. Engine dies while driving, no warning. My guess is that as coil heats up und


Hi, the reason for the engine to die when you turn, is because it make more effort while turning ,this is part of the same problem, if you dont have presure some times it can be the pump ,be sure you hear the pump runing when you turn the key ... 2002 Daewoo Lanos

Firing order on 3400 Four Cam24 - 1999 Toyota 4Runner


For the 1999 Toyota 4Runner 3.4L DOHC V6:\015\012Four Cams??\015\012\015\012Firing Order:\015\0121-2-3-4-5-6\015\012\015\012Cylinders:\015\012.......( ... 1999 Toyota 4Runner

What is the firing order for 2006 Toyota Rav4. Changing 3 thru 6 cylinder ignition coils.


HOPE IT HELPS ... 2006 Toyota RAV4

What is the firing order for 2006 Toyota Rav4. Changing 3 thru 6 cylinder ignition coils.


... 2006 Toyota RAV4

I have a 1988 Toyota camry that has had the spark plugs, plug wires, distributor cap, rotary button, and the ignition coil nothing has helped it will spin but not fire what else should I check?


... 1988 Toyota Camry

Why are cylinders 1 3 and 5 are miss firing 1997 toyota camry


... 1997 Toyota Camry

Firing order for toyota camry v6 1996


The firing order is in fact 1 2 3 4 5 6 the number one cylynder is on the left at the back, as you look at the engine from the front >>positions of cylinders-------------1 3 52 4 6 ------------ ... 1993 Toyota Camry V6

Not cranking I have a 1992 XJ6 Sov Jaguar That will not crank I can not get any fire out of the Coil I have change the Crank shaft position senisor the coil and coil wire and the ignition control module and still nothing no fire I do have fire at to the coil but nothing will come out. The code I see are PAO or PRO and it says fuse 1 and fuse 2 but all fuses check ok what am i missing??? Or what does these codes mean?


Did you change the camshaft position sensor? ... 1992 Jaguar Xj Series

'89 Mazda 323 1.6 non-turbo, driving when the check engine light came on and vehicle died. Replaced fuel filter, getting good fuel pressure, cleaned out the dist cap, found the ignition wire to the dist cap bad. Replaced it but checked the ignition coil and it has no fire. Got a new coil and checked, but no fire. All fuses under the dash are good, the four fuses on the firewall look good. What next??


Check the ignition module, poss near the distributer for heatsink (contact) paste on the base to draw the heat away from the module. With the engine light coming on, it should have thrown a code possibly a bypass ignition or no pulse while cranking. ... 1988 Mazda 323 Hatchback

No juice to #1 and #4 on the coil. Need to know # of the pin for the coil and the number of the pin for the computer box and what plug in for the computer box that fires #1 and #4. It does run but only on four cycliners. I already replaced the coil. I think it is a broken wire between the computer box and the coil but not sure.


Check this diagram to idenify coils...Hope helps. ... 2000 Chrysler Grand Voyager

Misfire my 2000 toyota camry solara check engine light is on and went to auto zone they say 1,3,5 coil is misfiring . we replaced coil 6 and 3. and code still says 1,3,5 misfireing... so one side of each coil is misfireing.. any suggestions what to do??


... 2000 Toyota Camry Solara

Error codes P0301(cylinder #1 misfire) and P0304(cylinder #4 misfire). Originally thought there was a failed ignition coil that controls cylinders #1&4. After putting new coil in, problem still present. Tested further and found there was no fuel coming out of cylinder #1 fuel injector. Tested injector and found proper power at injector but it wasn't duty cycling on the ground side. Ohmed harness from injector to ECM and found within spec. Back probed connector for all four injectors and found n


The ECM is very possible.I assume cylinder 4 injector is providing gas?The connection for cylinder 1 is probably a connector with pins correct?If you can bypass the ECM,that would get you closer if not give the answer.I would try using a wire straigh ... 1998 Toyota RAV4

My 1999 Pontiac Sunfire now will not start. It will crank, but will not fire. I had the ignition control module checked, and it tested good. When cranking, it acts like the firing order is off, but all plug wires are in the correct firing order. the #1/4 coil pack has a couple of fine cracks in the outer housing, would that cause the problem? Please help!!


CHECK YOUR FUEL FIITER & DELIVERY SYSTEM , PUMP SOLENIOD AND OIL FUEL SENSOR ... 1999 Pontiac Sunfire
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.0285 seconds