Having problems with your 1997 Oldsmobile Eighty Eight ?

1997 Oldsmobile eighty-eight blower fan not working. Hardwired blower motor and it works fine, replaced blower relay, tested blower resistor with ohmmeter and it checks out, swapped out climate control panel, no power going to resistor, there is power to relay via red wire, both fuses are good. Any advice/suggestions would be greatly appreciated

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Blower motor resistor
Repair Help & Product Troubleshooting for 1997 Oldsmobile Eighty Eight

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1997 Oldsmobile eighty-eight blower fan not working. Hardwired blower motor and it works fine, replaced blower relay, tested blower resistor with ohmmeter and it checks out, swapped out climate control panel, no power going to resistor, there is power to relay via red wire, both fuses are good. Any advice/suggestions would be greatly appreciated


Blower motor resistor ... 1997 Oldsmobile Eighty Eight

No heat no power coming out of my blower motor relay and I have replaced the relay twice fuse is good and resistor and blower motor are to there is a purple wire going into my blower that gets no power


If the relay is getting no power that's the problem. There are 2 sets of power going to this relay, the control signal (the power that comes from the switch on the dashboard turning on the relay), the second is the much greater power supp[lied to th ... 1990 Chevrolet Caprice

Heater blower will not shut off after ignition is turned off an key is pulled.Purpule wire to motor has power going to it with dash controls out of dash. This is a 2oo2 olds Aurora with 92kmiles.I put new brushes in blower motor an when I plugged in harness blower motor started running half speed with on ignition off! So I pulled relay box next blower motor an has one wire with power going to it,thats puts power to purpule wire to blower.


Could be a faulty relay , pull relays out one by one and see if stops running ... 2002 Oldsmobile Aurora

The blower or fan works on all speeds but high, have power out on all wires at switch, under hood at resistor no power on high. does that speed have to go through a relay first.


... 1995 Chevrolet Blazer

Reattaching blower motor resistor - jeep has climate control (dual). I have the part but I forgot which wires go where to resistor. there are three coming from backwall to resistor one red and one black, the other one which is striped I see from last hook up goes to middle. the other red and black that come from resistor goes to blower motor. I need to know if where the red one and black one goes. the red ones is thicker than the black one


... 2001 Jeep Grand Cherokee

Blower motor won't work. Switch and blower resistor check out ok. No power at the blower motor. I suspect the blower relay, but even though this relay is shown in my wiring diagrams for the 2002 F150 regular cab pickup, I can't find the location of this relay in my owner's manual. Where is it? Thanks in advance!


In there\015\012 you have four devices to check out to pin point the problem: the switch it's \015\012self, the blower relay switch, resistor block, and the blower motor it's\015\012 self.I find this information in the Haynes ... 2002 Ford F150 Regular Cab

I have a 1994 Safari. I have removed the fusible link connector (at the battery) and cut it out of the wire harness. Now that have the new one I don't remember which circuits go to what fusible links. The connector pins are labeled A, B, C, and D. The circuits are the Anti-lock module, the HVAC blower motor relay (under the hood at the front evaporator), and two go to the fuse panel under the dash: one powers the front and rear HVAC blowers and one powers the head lights (among other things). Th


... 1994 GMC Safari

2000 mercury Mountaineer Where is the module for the driver power window. The window will go down but not up. i have power out of the up and down button and the relay seems to turn on but i don't get power to the red wire to the motor.i replaced the relay. I'm trying to pull the motor but i found 2 bolts and i think the third one is a rivet


If the window operates one way but not the other direction you have a short in one wire The motor is fine if working any directionIf the motor was at fault it will not work at all.Check all connections from the switch to the motorLo ... 2000 Mercury Mountaineer

Follow all advise given so far on my 1991 chevy truck which has the heater control blank, no heater , no a/c doesn't lite up. change relays under the hood like you said and check the red wire for power , unit has power but does not lite up or function. we hear a clicking sound when we plug the control module in over by the heater blower , is there a relay there or give me more help. thanks vince


The advise given to check your unit for power was correct. The relay is before the unit if your sure you have power and a ground on the unit and it is still not working then it died. You will need to get a replacement. \015\012\015\012 ... 1991 Chevrolet S-10

1991 tracker I put in a new fuel pump relay. the new relay has power comming to teh relay the wire going to the fuel pump has no power. put the jumper wire in and the pump runs. Why won"t the power go through the relay?


Probably becuase its faulty...try replacing it and go from there...or else there is another source of resistance in the circuit some where....also, check your fuses....a blown fuse will stop flow of current as well. ... 1991 Geo Tracker

2003 GMC Yukon XL - same as Suburban ("Rear Blower Motor / Fan Not Working") I got 12V actually 13V at the Orange wire in to the resistor. The blower motor 2 wires come from this resistor. I changed the resistor thinking that was the problem and still same thing. The resistor has 3 wires going in Orange that has 12V, Purple in the middle and Black Ground. I looked for a rear blower fuse - in the engine compartment and it is not labeled? Any sugestions where to start or look next?


You don't have any voltage to the blower motor? Are you getting power to the switch? ... 2003 GMC Yukon XL

1995 heater blower motor: someone has replaced it before my sister bought it. The problem is it is wired incorrectly, the blower runs only on high continuously no mater where the fan speed switch is located. Upon inspection it aperes that someone wired it straight to hot. (always on) I'm not sure how to wire it, and I think the resistor is not working. I want to know where the hot wire goes and where the two wires from the blower go. The black is obviously ground. It has a 1 wire plug go


Since its presently working, don't mess with it yet. You can put a toggle switch in between so you can turn it on and off (you can even mount it under the dash). Get a good wiring diagram and use it to make sense of what you have.(Chilton makes a goo ... Ford Escort

Gauge fuse OK / Fuel gauge not working/ Drop tank and check yellow and red wire to sending unit- no voltage/ pulled insturment Panel and pulled wire connector that deals with fuel gauge/ check yellow and red wire going to insturment panel no power/ where does power come from to feed yellow and red wire? is it the instrument panel it self? Sending unit seems OK resistance checked with omh meter.


You do not measure voltage on the red/yellow wireinstead you need to read RESISTANCEthe gauge uses power and then the resistance change of the red/yellow wiremeasure resistance of the yellow/red wire at the cluster ... 1989 Toyota Pickup SR5

1995 Isuzu Rodeo with 3.2L v6. With no power to the fuel pump. I've checked the continuity on the fuel pump wires they seem fine. No/low voltage on the wires to the pump, (.08 volts when DMM is set to 20). Checked pump after removing the tank and the pump, it purred. Checked the fuel pump relay it seems to have power on 1 circuit, (not sure if 2 circuits should have power(?)). Then checked with a known good relay. Then tried jumping/bypassing the relay. The schematic show the power should go fr


Maybe a fuel filter clogged, or a relay to your fuel pump. ... 1997 Isuzu Rodeo

I just replaced my factory stereo in my 2002 honda accord. i have two red wires left over that appear to be my dash lights. i dont know where to connect these two wires to make the dash lights come on when the head lights are turned on. if i connect one of the wires to either of the power wires the dash lights stay on all the time. if i connect the other red wire to either of the power wires my lights that tell me what gear im in go out. WHAT DO I DO WITH THESE TWO WIRES? Thanks so much Kev


I have no idea about the wire that puts out gear position lights. But the one that makes dash be on constantly, is the memory wire for radio. You do need continuous power for radio to remember stored radio stations, audio adjustments and last source ... 2002 Honda Accord

No power going to the compressor or low pressure switch for the a/c. wire loom melted for the resistor, on a 2007 2500 dodge mega cab 4x4 with 86,000 miles. Blower blows warm air.Freeon is charged with 1lb 10 oz.


... 2008 Dodge Ram Pickup 2500

I connected battery terminals backwards for a brief time and smoked the fused lead going to the power distribution center (fuse panel under hood). I have reterminated the wiring and cleaned it up but the following does not work: Radio Speedometer Temp Gauge fuel gauge radiator fan also, when plugging relay in to blower motor it constantly runs. Everything else works, we need this van for transporting our wheelchair bound son. Any info would be appreciated. Thank you, Joe


It sounds like you shorted out quite a few things. Unfortunately, it sounds like you'll have to trace all your wires to see where the shorts are. I believe that several of your wires have fused together ... 2000 Dodge Caravan

I purchased a 1996 Blazer LT with the engine out and tore apart, all of the parts were in boxes. I have it all back together now ready to start. My problem is I have no power to the body. I have no wire feeding the body. On the battery I have a large black wire going to the starter, one large red wire to the alternator and one small red wire goes behind the battery with a plug that goes into the wiring harness. Trying to find out does the feed wire go from the battery, alternator or starter and


The small red wire should feed the fuse box (i think) ... 1996 Chevrolet Blazer

Fuel pump not running. put gas in air intake and engine runs about 1/2 minute. I have 2 different haynes manuals but the schematics don't match my car.. Manuals have relay with 1 wire going to fuel pump. My car has a plug on the back of the gastank with 7 wires. (red and black wires twisted together, white and brown twisted together---these go to the same plug on the tank and I traced them back to the ECM module--the red and black go to pins 11 and 12. Don't remember what the numbers were for wh


CHECK FUEL PUMP AND FUEL INJECTOR FUSE AND CHECK FUEL PUMP RELAY.IF ALL IS GOOD SCAN TO SEE IF YOU HAVE PCM FAULT CODE.IT CONTROLS FUEL PUMP DRIVE CIRCUIT. ... 1993 Chevrolet Cavalier

Third blower motor resistor and blower either keeps running or nothing at all. Took out control panel (HVAC) tested all connections and they are fine. The blower motor relay is working also. Leaning towards a short wire but when all wires test out okay I don't know where to lean to next. Also noticed my ignition is very touchy and not working like it's suppose to. R/R cabin filter and it was full. That would explain the first resistor blowing out but after the 3rd resistor and chec


... 2004 Chrysler Pacifica

Car won't start. There is no spark at the plugs. I replaced the Camshaft Sensor and Crankcase sensor. Checked to see if there was 8 volts going to these components and nothing. Checked the power going into the ASD and Fuel Pump relay with key on and have power to the 85 slot on the ASD and power to the 86 slot on the fuel pump. Jumped from the 30 slot to 87 slot on the ASD relay spot and checked to see if wire was bad going to coil, it is good. I'm clueless at this point.


Check your fuses if they are all good ,check all the ground wires on the engine make sure they are all making good connections,and if still not starting then its a very good chance that your PCM (computer) is bad. you can buy a used one for little mo ... Chrysler Concorde

I have a 1983 Ford F-150. I replaced the water pump and power steering pump on it. When doing this the wires cam loose on the alternator. Now I can not remember where the black and red booted wires go. I know that the large black wire goes to the large red insulated stud, but there are four more that the other two wires could go.


Hello Brian.There should be letters at each terminal.Orange /black goes to "F" terminal.And if yours has 2 white/ black they both go to the "S" terminal.There you are.KL ... Ford F-150

Blower motor no high speed. Replaced resistor (3 Times, keeps burning out) replaced wire going to resistor. it burned out . replaced blower motor with new resistor . resistor and wire burned out . i have low and medium , no high


... 2005 Chevrolet Astro

I installed the wiring harness for a 2012 honda pilot- I had to use and adaptor to go from 7 wire to 4 wire ,I had power at the 7 wire plug -my trailer wiring was not correct so while I was trying to wire the trailer I left the wires hooked up and the power to the 7 wire plug on -by accident I touched the ground and hot wire together and now I have no power to the 7 wire plug and I checked the fuses in the front of the vehicle and they are good not sure where to look next . maybe the relays on


... 2012 Honda Pilot EX-L

Hey guys, Okay I have a 96 seville sts that stopped running on me while driving. It smelled like burnt wiring so I popped the hood and noticed that it melted a relay under the hood. It was a relay harness with an orange wire. I traced the wire all the way back to the trunk. It was melted clear back to the trunk. Now I have no power to everything except the door locks power seats truck release, and the center console blower motor. What do you think it could be? I know I have to change the body h


I dont beleive u need anything reprogramed but u do need to figure out what caused it to melt in the first place ... 1996 Cadillac Seville CA Value
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4712 seconds