Having problems with your 2002 Toyota Camry ?

Toyota 2009 camry battery jumped and restarted but it needs computer reset because of it. Any way to do it without going to dealer? Once I turn it off it wont restart

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2002 Toyota Camry

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Toyota 2009 camry battery jumped and restarted but it needs computer reset because of it. Any way to do it without going to dealer? Once I turn it off it wont restart

... 2002 Toyota Camry

Toyota 2002 camry battery jumped and restarted but it needs computer reset because of it. Any way to do it without going to dealer? Once I turn it off it wont restart

To reset, disconnect neg battery cable for 10 minutes, re-attach (make sure battery is fully charged before hooking it back up. ... 2002 Toyota Camry

When I turn the key on two lights come on, when I start the bike the lights go out and the check engine comes back on for about 15 seconds while the bike is running and then goes out. The bike performs good it only shut down one time when I noticed the light on. I tried to restart it and it wouldn't start until I turned everything off and then turned it all on again as if to recycle it. The dealer told me that it was coding out and they could read the code for 37.50. Is there a way I can

Something wrong with your car,you should get a code scan tool clear the fault codes. ... Cars & Trucks

2008 chev impala turn car off but key wont go to last postion to get key out there is still power on the dash and the engine is off the car will restart fine putting car in park foot on brake shifter in park all the way to forward still wont let key come back far enough

Those had alot of problems with the ignition switch. remove and replace switch, good luck. ... 2008 Chevrolet Impala

Security light comes on and car wont start. If you turn the ignition to the on position and leave it on for about 10 to 15 minutes, the light will go off. The only way to start it after that is to completely turn the car off and restart it.

... 2002 Oldsmobile Alero

Hi, I got an 09 Audi Q7 with 11,400K miles. Getting "Service Due!" on the display. Is there any way to have that reset or turned off without going to the dealer and without use of VAG tool? Appreciate any suggestions and responses.

Not, is it not possible to have that reset or turned off "Service Due!" without using a diagnostic scantool connected to the data link connector of the car. ... 2009 Audi Q7

Woh can i change brake disks and pads on audi a8 2005, rear hand brakes aon this model r electric and the piston on the caliper wont open to allow the new discs and pads into place. is there any way that i can do this my self without having to go to the dealers?

Do NOT do this if you have the electronic handbrake You need the proper reset tool, if you push and twist the piston you will break it have to change the caliper approx 200 each. You can replace the discs and pads no issues but ensure you have someon ... 2005 Audi A8

I own a 2000 Jeep Grand Cherokee Laredo, 4WD automatic 4.0. I have been having issues with the transmission. It seems the gears are slipping at times. Last week after about 200 miles on a trip, I was going about 70 mph and suddenly it was like I had shifted into Neutral and the rpm needle went to about 4. When it happened it almost felt the way it feels when you have a flat tire. I turned the car got off waited a minute then restarted and was able to drive off the exit ramp without a proble

... 2000 Jeep Grand Cherokee

The keyless remote died on our 2003 hyundai elantra. We ordered a new one. How can we turn off the alarm once we open the car? And is there a way to program the remote to the car without going to the dealer?

Here are the steps to re-program key less entry remote for Hyundai Elantra. This procedure is good for Elantra 2001 to 2003; Elantra 2004 must be programmed by the dealer. The ETACS unit, which controls the alarm, is bolted to the dash ch ... Hyundai Elantra


The anty theft controler is U/S.Hope this helps. ... 2007 GMC Yukon

2005 acura rl had battery with low startup voltage, tried to start the car and it didn't at first, second try it started however the Rear power windos and auto self lock feature turned off. now rear windows can only go down witht the switch at each door, not the main driver switch. i took it to Acura dealer and they said they had to reinizialyze the power windows and features, it happened again right before i went to buy a new battery, is there a way i can reinizialze this windows without paying

It may reinizialze its self once you take battery out and put new one in. The computer modulator resets when you take neg. side of battery off. So that should work. If not try asking at Advance Auto or one Auto parts stores. ... 2005 Acura RL

The cluth occasionaly will not disengage. It will work perfectlty for a week or so then as you are driving and go to change gear the pedal goes to the floor with no resistance but does not disengage the clutch. The only way to get it to work is to turn the car off then restart the car. The master cylinder appears ok and does not leak oil. The local Mazda dealer cant find the problem.

Consult to the authorized mazada sevice center near you, they will definately fix the problem. it seems the hydraulic system problem. which need to be delt technically. ... Mazda 323

Headlight switch When I was turning on my headlights the switch came off. The piece that it goes to is loose & go back in the hole. I can reach it & pull out with pliers. Is there a way I can fix it without taking it into a dealer? Thanks for your help & time. Chad

REMOVAL & INSTALLATION\015\012See Figures 1 and 2\015\012\015\012Disconnect the battery ground cable. \015\012On 1991-94 models, perform the following: \015\012\015\012 ... 1998 Ford Explorer

Key doesnt turn! We have used two keys a key that wasnt for the car that worked and a the key that worked. We used the wrong key to start the car then parked and now when we went to start it using wrong and right key, the wrong key wont go all the way in and wont turn in the column and the right key goes all the way in but wont turn. We have moved the steering wheel shitloads and rocked the car back and forth but still nothing thanks guys

Sounds like the key cylinder is bad! the way u described the problem sound like an older car and the original key looks worn or is rounded at the edges ... 1992 Plymouth Voyager

I have a 97 subaru impreza outback sport that wont start. i turn the key all the way and it does nothing. the power is on but the engine doesnt turn over. I think it is linked to my shift lever though because my shifter moves freely between the gears instead of me needing to put in the brake. Also the car wont go into any of the gears. wont go into park nothing.

... 1997 Subaru Impreza

Error message gos on dash(where the miles are displayed), all Gages turn off. gas-rpm-mph-temp- go to "0", all sensors go crazy, low fuel light,-check coolant- ABS light go on. and this is all while its running & i'm drivein, once i turn the car OFF it will not turn on- error messege stays on, when i turn the key u can here the fuel injector,, i've tryed to take the battery off and put it back on-it worked, but then it turned off on my way home, and now it wont turn on at all. Comments: Sep 05,

... 2006 Chevrolet Malibu

Hi my toyota corrola 2003 wont go in reverse it would go forward but when I tried reversing and making the turn it will just stop it wont make me turn it all the way I'm not sure what is causing it. But when I checked the wheel one of them isn't straight it looks like it is coming off because the rest are just straight.

Could be some vacuum leak or trans valve solenoids stucked. ... Cars & Trucks

I bought a 1996 Jetta GLS, drove it home with no problems. This is my first car and wanted to learn how to drive a stick, i killed it of course but now it wont even start again. I turn the key all the way and it wont even sound like its trying to start. I dont think its a battery thing because my radio and the digital clock and milage show up still. Also when i turn the key all the way over the gas gage and temperature gage go crazy. iv tried starting it in different gears too and nothing...plea

This vehicle will not engage the starter until your clutch is pushed in all the way. try putting the car in neutral and then pushing your clutch all the way to floorboard, then try to turn the key to start position. the car should start now. ... 1996 Volkswagen Jetta

Horn malfunction My horn had a few episodes of going off continuously without warning until I tapped the switch a few times and it turned off. Then it sounded and didn't shut off. In a pinch, I pulled the fuse to turn it off and am driving it without a horn. My mechanic tells me the least expensive fix will be $800 for a whole new used assembly. Is there a way to safely disassemble this area (involves the airbag area) and investigate the switch diaphragm and see if there is a way to repair it? A

Never work with live airbags without consulting the factory repair manual used by dealerships ... 2001 Jeep Grand Cherokee

I have a 1998 dodge 1500 the intermittent cycles on my windshield wipers will go up half way and stop then go all the way up an stop and so on ( very intermittent) but the high and low cycle works fine ust wont turn off in the park setting wherever u turn it off they stay.

Sounds like you have a bad multi function switch ( the wiper switch that is also a turn signal switch) ... 2004 Dodge Ram 1500

I have a 1989 ford ranger five speed manual 2.3 liter 4 cyl i am haveing problems gettin it to go into gear and the clutch is also in the floor but if i turn the truck off it will go into gear and if i shift all the way down it will go into gear fine but if i stop in neutral it will not go back into gear than i have to turn the truck off put it in gear than take off i am thinking slave cylinder but im not sure and also i will have it in gear and press in the clutch but it wont engage so it just

Do this...make sure the reservoir is fullengine off and pump the clutch pedal slowly about 5-10 timeswhile holding the pedal down have assistant open the bleeder on the master located in the transif you get a good ... 1989 Ford Ranger

I have a 2004 Cavalier LS automatic. Yesterday, when I took off from and stoplight my thermostat needle went from the half way mark up to between the 3/4 mark and the red zone. When I turned the engine off the needle didn't go all the way back to 0 as it normally does. This morning when I started the car the needle stayed just at the half way mark, however when I turned the car off again and restarted it the needle went to the red zone and only came down to the 3/4 mark. do you think it coul

Sounds like your thermostat is bad or at least sticking. Replacing it is faily simple and even the good ones are less than 20 bucks. Hope this helps! (rate if useful) ... 2004 Chevrolet Cavalier

For the last few years the dash unit would flash leds, or not let you switch from circulate to fresh air. If the system was on heat when you turned the car on it would not go to cold when the thermostat was turned to the blue zone. The only way to get it to go cold was to shut off the engine, turn it to the cold zone and restart the engine. I could live with this, now it will only blow lukewarm air. I am thinking it is the dash unit, thoughts?

This control head can be tested for proper function by any Chevy dealer, as the control head is around $400.00 I suggest you do that, the problem is most likely the head unit based on my experience with this type of problem, but there is no guarantee ... 2001 Chevrolet Tahoe

My rear drivers side seat belt dosn't retract the way it should, it gets all bunched up on one side. It looks the same as the one on the other side of the car and it seems like it's on a bad angle to collect the belt. Half way through and it bindes up and wont allow the belt to come back out. I can force the belt to go all the way in by turning the spool by hand, but that is just a big pain in the ahh hand.. any tricks to solve this. eg. can it be adjusted or turned to allow it work as it should

I'm sorry I do not have a solution as to how you, yourself can fix this problem, however by fooling with it you run the great risk of damaging or jamming it up so that it will be USELESS in an emergency.\015\012\ ... 1999 Subaru Impreza

My 1995 ford thunderbird wont turn off after starting I can kill the power and turn it off.. replaced igniton switch and ignition cylinder.. Still cant get it to catch going backwards.. Someone please help me...It feels stripped almost when going backwards to turn key off but I can restart the vehicle..

... Ford Thunderbird
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.0701 seconds