Having problems with your 2005 Chrysler Town & Country ?

Describe your 2005 Chrysler Town & Country Problem HOW DIFFICULT IS IT TO CHANGE FRONT CRANK SEAL?

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

It's not too bad to change, you will need a special tool to remove the crank pully, it looks like a 3 jaw puller and once you get that off the seal is right behind it. Make sure to clean the crank pully shaft that goes through the seal with a piece of emery cloth to prevent leakage and coat it with either transmission assembly lube or a small amount of motor oil to prevent a dry start that can damage the seal again
Repair Help & Product Troubleshooting for 2005 Chrysler Town & Country

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Describe your 2005 Chrysler Town & Country Problem HOW DIFFICULT IS IT TO CHANGE FRONT CRANK SEAL?


It's not too bad to change, you will need a special tool to remove the crank pully, it looks like a 3 jaw puller and once you get that off the seal is right behind it. Make sure to clean the crank pully shaft that goes through the seal with a piece o ... 2005 Chrysler Town & Country

How change front crank seal on 2000 chrysler town country 3.3


... Cars & Trucks

Hi im working on a 92 volvo 740 with the 2.3 non turbo. the problem is i just did a motor swap the old one had "hard knocking " drove car in ran fine but loud. did the swap- while it was on the stand we changed the following. in too the new engine, front and rear main seal" crank seals",timing belt, water pump, thermostat,plugs,wires cap and button. everything went smooth...the problem is it will start but spins over alot,runs only at like maybe 1000rpms with the throttle wide open, then dies.


NEED ADJUST SET IGNITION TIMING.MOST TIME YOU INSTALL ANOTHER NEW ENGINE.THE IGNITION TIMING AT DISTRIBUTOR OFF TIME LITTLE TOO FAR ADVANCE CAUSING WEAK SPARKS FOULING OUT SPARK PLUGS. CHECK FUEL PRESSURE SOON AS ENGINE STOP AGAIN DONT TURN ON IGNI ... 1992 Volvo 740

2005 Chrysler town and country van has lose power. When driving it goes from 0-70 in about 15 seconds, it appears not to have much power when trying to get up to speed. If you press down on gas to try to get up to 40mph very quick, the RPM go up, but you must let off the gas for it to change gears. However, it eventually does change gears. The check engine light is on and the code reads p0404 and p0420. I replaced the EGR valve, still same problem. I disconnected the catalytic converter an


Change plugs, wires, and fuel filter. Get a cold air intake or at least a k&n air filter.\015\012Clean the throttle positions sensor. Check for any vacuum leaks. After every sensor that you replace you have to reset the computer or the code wil ... 2005 Chrysler Town & Country

2003 Chrysler Town & Country. My automatic climate control air conditioner won't turn off unless car is off. It's on full blast cold and none of the A/C controls do anything to change it (on/off, temperature, fan speed, etc.). It's only a problem on front a/c, separate rear a/c is fine. While the car is on, they only way to stop the A/C is to pull the fuse relay to turn it off.


Its a mopar get a chevy ... Chrysler Town & Country

I HAVE A 1996 PLYMOUTH VOYAGER AND MY PROBLEM, IS THAT WHEN I WAS CHANGING THE FRONT SEAL ONE OF THE PULLEY MOVED SO I AM HAVING TROUBLE TO TURN IT ON ONE OF THE ARROWS I POINTING TO THE FORST CYLENDER PLEASE HELP ME ON HOW TO SET THE ARROWS AND THE CRANK SHAFT..


... 1996 Plymouth Voyager

2002 jeep liberty front crank seal - 2005 Chrysler Town & Country


... 2005 Chrysler Town & Country

Change front crankshaft seal,how do I change front crankshaft seal from my Nissan hardbody 2400 SE 1997 twincab.there is oil leaking from below water pump assembly so I suspect crankshaft seal problem


... Cars & Trucks

I changed the front head on my 97 chevy malibu ls 3.1 l. now having problems with it cranking. it tries to crank pops and that's it. starter kinda draggy but would that be the problem?


... 1997 Chevrolet Malibu

Starting problem I have a 1999 Chrysler town & country 96,000 one owner miles, will crank 3 times, shut off immediately, the 4th time it won't do anything. Let it set for a while, it will crank up and go on.I have tried about everthing, been in dealer 4 times, they can't fine the problem. Any help will be appreciated.


My van is doing exactly the same thing. It will crank, then cut right off, after I try 3 times it doesn't do anything. After that it may not start for a couple of days, but if I leave it alone after the first or second try it may start back in an hou ... 1999 Chrysler Town & Country

I have a 94 GMC Safari, it won't shift out of 1st gear, the ABS light is stuck on, and the speedo doesn't work. At first the ABS light would come on and off, when the light was on the trans would't shift, when it was off it shifted fine. Now it's stuck on and won't shift. The computer was flashing a vehicle speed sensor code. I changed the vehicle speed sensor and the van still has the problem. There was a trans flush and a front pump seal and rear tail shaft seal, and trans filter changed.


... 1994 GMC Safari

2000 go tracker bad oil leal back of motor have changed rear main oil seal front trans seal oil pan gasket still leaking even changed crank sensor oil ring &sensor .


It has to be an oil pressure sending unit. There are two of them on that SUV but they are in different places depending on your engine cord. If you go to Advance Auto parts or O'Riley, they will tell you exactly where to look. ... 2000 Chevrolet Tracker

Dear Expert, I have two very difficult problems with my 1997 Chrysler Van Town & Country and I would REALLY appreciate it if anyone can help: Problem#1 : The Leak detection pump (LDP) keeps failing ? The LDP has been replaced 4 times by a Chrysler dealer in my city ? Petaluma in California. Each time a LDP failed about a week after a new one was replaced ( the dealer keep replacing the LDP pump switch because they already run various tests with the emission system but couldn?t find


Hello, I saw your problem and want to suggest several things which other car makers have on their A/C systems and to comment on the Emission problem.\015\012\015\012First, the Climate controls on some A/C units have their own self-diagnos ... 1997 Chrysler Town & Country

My 1996 Town & Country Chrysler has a front end shimmy that starts at 40 mph gets worse and then disappears about 50 mph. Had the front tires balanced with no change. The shimmy goes away if I get off the gas. It ONLY happens when the car is under power and accelerating. Just had new bushings and links replaced. No change. vehicle has 110,000 miles and new tires.


... 1997 Chrysler Town & Country

Had oil changed at station ,on the way home noticed oil leaking from timing cover area dissasembled timing cover and found crank seal blown out of position removed all other componets and also changed water pump because seemed to have residue at drain hole while apart I noticed there seemed to be a bit more play in the crank side to side or left to right ,replaced all components damaged by oil re: timing belt and reassembled tested & found it to repeat exact problem again others suggest replace


If the cam is walking around due to worn thrust bearings or cam then it will quickly destroy the oil seal, so that is where you should look, there is a spec for cam movement, about 0.15 I would guess, but verify it in a service manual. ... Hyundai Elantra

Describe your 1999 Chrysler Town & Country Problem-Won't start up all the time, takes me 7-9 cranks for it to start. sometimes it starts with no problem at all. Someone told me my battery was too small for the size of the vehicle. Starter was replaced 3000 miles ago. Battery sounds like its dying after repeated cranks to get it started sometimes. Three hours later I start it right up.


Does it not start hot? if so it sounds like a crank sensor ... 1999 Chrysler Town & Country

I have chrysler Avenger 2.5l that would crank but no start. checked for spark it does have but assumed the crank pos sensor was faulty. changed it but stilll acted the same just cranking cranking cranking with a few sputters. finally started but is running really rough, smells bad. what could be the problem, plz help!


Fuel pump, check fuel pressure. or clogged catilitic converter ... 1997 Dodge Avenger

Hi folks. I have a 2000 Chrysler Town and Country Van. I am occasionally experiencing a problem with my front brake calipers not fully releasing, causing drag and overheating. I replaced both calipers yesterday only to have the problem reoccur the same day. Is this actually a ABS control valve problem, or a metering valve problem. If this an ABS problem can it be repaired? Thanks. ED


Sounds more like a bad brake hose. Did you replace them? ... 2000 Chrysler Town & Country

How to change the front crank shaft seal on a 2000 jimmy 4.3l


... 2001 GMC Jimmy

I have a oil leak ever since i bought this car. I've changed the head gasket, front crank shaft seal, valve cover seal, and oil pan seal. Could using the old head bolts cause this? I've read that it could be my oil pump too.. please help..


NO if you have been using oil and loosing oil from all the seals and rocker cover and sump gasket then its caused by a thing called BACK PRESSURE,and that is caused by the piston rings worn, or broken top compression rings and a lip in the bore causi ... 1993 Honda Civic 4 Door

I am getting codes to cgange my crank sensor and cam sensor i changed them. I am having a problem my durango has a 4.7 and im having a hard time starting it. It takes a few cranks before it starts then it runs good untill i stop at a red light and it wants to stall. My brakes are also going to the floor and kicking into the abs. I have new brakes front and back. checked codes still coming up crank and cam sensors and intermitant o2 sensor. Help


It could have worn timing guides which would cause the timing to be off a bit causing loss of sync ... 2002 Dodge Durango

Coolant Problems I've been doing extensive work with my 1999 Ford Taurus 3.0L OHV. I have replaced all engine gaskets from the head gasket up, the front bank cylinder head (#'s 4-6)- the rear bank head only had a maximum of 20% leakage on the leak-down test and showed no signs of warpage (used a feeler gadge and razor blade set at a myriad of angles and positions to check). We have changed the timing chain, front engine cover gasket (timing gasket), front oil seal, water pump, radiator cap, flus


Hi there. It sounds like you have done the most obvious checks and I can assure you by-passing the heater core will have no effect. There are three possible causes that you need to investigate further and you will need specialist equipment for it - ... 1999 Ford Taurus

I have a brake binding problem i changed the master cylinder twice,change the flexible brake lines and changed the seals of the front calipers and cleaned the pistons of the calipers too.


If you have a frozen caliper, (rusty piston stuck inside calipers cylinder), then you have to options:Replace the caliper piston and sea,l with a new one, or replace all thing i.e, the caliper. Hope will help. ... 1996 Toyota Corolla

Changed front brake pads on 2000 Town & Country, bled the brakes back to front. When depressing the brake pedal it goes close to the floor before the vehicle is able to stop. What could be the problem?


U NEED TO BLEED THE BRAKES USING A SPECIAL TOOL THAT HOLDS THE ABS HYDRAULIC CONTROL VALVES OPEN, ANY GOOD BRAKE SHOP WILL HAVE THE TOOL OR THE DEALER, SORRY BUT THAT IS THE WAY IT HAS TO BE DONE. ... 2000 Chrysler Town & Country

I have a Chrysler 2003 mini van town and country, with 74,000 miles.Since when it was at 70,000, it started stopping at every stop signal,in slow motion when the engine is started. I got changed the fuel filter and the spark plugs. of no use.Now the mechanic recommends to change spark plug wires. I am not sure that it will help. Some times it runs perfectly all right with no problem at all . Any good suggestion ?


This happened to me. The valve that controls the air intake gets stuck which stalls the motor. I removed the air intake hose and wiped it clean using Acetone (nail polish remover). Its been running perfectly ever since.... ... 2003 Chrysler Town & Country
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.9948 seconds