Having problems with your Dodge Ram 1500 ?

Where is the vehicle speed sencor on a dodge ram 1500 V8 cyl. 1998 . the book says its on the tranny or rearend or could be on the steering colume. can't find it.

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

For 1998 Dodge Truck RAM 1500 1/2 ton 4WD 5.9L MFI 8cyl the Vehicle Speed Sensor is located:\012\011\011\011\011\011\011\011\011 \012\011\011\011\011Transmission / Transfer case
If its a 4x4 its in the transfer case near the back on the housing the drive shaft goes into. The one in the rear end is located dead center on top of the differential.
Repair Help & Product Troubleshooting for Dodge Ram 1500

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where is the vehicle speed sencor on a dodge ram 1500 V8 cyl. 1998 . the book says its on the tranny or rearend or could be on the steering colume. can't find it.


For 1998 Dodge Truck RAM 1500 1/2 ton 4WD 5.9L MFI 8cyl the Vehicle Speed Sensor is located:\012\011\011\011\011\011\011\011\011 \012\011\011\011\011Transmission / Transfer case ... Dodge Ram 1500

When accelerating my 96 ford taurus from a stopped position, it seems like it cant find 1st gear if I accelerate too much at once, but if I take off slowing, it runs great. Had tranny serviced and found out the tranny is in great shape. A friend says sounds like the electrical coil is bad. Could this be true?


It sure sounds like the trans is slipping, buy your discription of the problem is not very clear to me, so that may not be the case, I would suggest you have the electronic engine and transmission control module tested for fault codes, if a transmiss ... 1996 Ford Taurus

Put me Toyota emina in for a mot .it failed on nearside rear suspension ball joint offside rear suspension ball joint im trying to buy them but cant find them is it because its called some thing different in the book. it says front ball joints but no rear could u help me lee


Hi.it could be listed as a tie-rod end, or tie-bar end.it may also be shown as a stabiliser bar.you may find you have to buy the complete rod as some of the ends were not removable.it may be worth asking the mot tester i ... Toyota Previa

I have a 1981 chevy cheyenne. It was a straight 6. I put a 350 and t350 tranny and a new steering colum everything works but the brake lights stay on. I cant find this switch i keep reading about it. Wiring mabe?


... Cars & Trucks

I want to put power steering fluid into my mercedes sprinter van, 53 plate, and dont know how to do it. i have looked at the engine and cant find a compartment especially for steering fluid. Could you advise me on this matter as when i start the van in the morning i hear a whirling noise from the power steering which leads me to believe it needs topped up. thanks you very much


... Mercedes-Benz Sprinter

Changed steering colume, works fine.Power w. don't work.No power to windows fuse in box. Theres a internal locking flnger connector hanging down about 10 in. left of steering colume.No luck where it goes.Don,t know for sure if this is why windows don't work, The windows worked before installation of steering colume.Could you please tell me where connector goes? Also I best find a fuse box diagram, could you help me on this too please. Sincerely,Keith.


What year is the Lincoln? I will try and find you some manuals or at least a wiring diagram so you can figure out the windows. ... Lincoln Continental

I changed the pitman arm and now my steering wheel isnt exactly right , turns more one way than the other by 1/4 turn ..when i tested it on the road the steering wheel is half cocked ..could this be an alignment prob.. Done every thing the book says ..except marking the pitman arm bit believe i got it centered.. Can any one tell me what i did wrong


... 1999 GMC Yukon

My horn doesn't work, the air bag light is on and the back light for my D (drive) for the automatic transmission is off. I checked the fuses and don't ssem to find a bad fuse. One thing I noticed is there is a dragging noise in the steering colum when I make sharper turns. Could there be a short in a wire in the steering column.


... 2001 Toyota Sequoia

Me and my wife brought a 2001ford van from a best buy autodealer and they dont know the door code and the ford dealer wants to charge us a outrage price to find it.but the van booklet says its in it,but we cant find it,so could yall please help us out!


Open the tail gate and look on the hinge, alot of them are placed there for" just in case" on a small white tag. ... 2001 Ford Windstar

II have a 1994 sedan devill the power steering dosn't work the reservoir is full of fluid and I can't find any leaks the drive belt is tight there is no noise comming from the pump even when you turn hard to one side and hold it do you think this is a bad pump or a problem with the steering gear it turns smooth just very hard also the book mentioned somthing about a pressure controle valve and manifold on some models on the rack and pinion so could this pressure valve be bad if so were is it an


This is hard to tell what is wrong, without doing some tests. I would say that the actual power steering pump is the problem. The Deville had lots of problems with the power steering pumps had lots of problems in these cars. ... Cadillac DeVille

I need an exploded view of a gm 700r4 tranny,ive been to 16 web sites already including this one they ALL say they have exploded views and diagrams im so sick of trying to find out something on these stupid websites and being sent in circles to find out they dont have what you ask for why do you advertise something you cant deliver?????????????


This is a social web site\015\012We are at home like you\015\012You must be looking at some\015\012paid feature\015\012\015\012\015\012If you want a 700R4 Manual\015\012go to ATSG.com and buy it ... Chevrolet 1500

My Mechanic cant find the AC relay in my 99 expedition. The blower stopped working when they replaced the turn signal wiring. Book says its near the glove box, they say it isnt.


See that long oblong piece on the dash, Kind of looks like a soap dish about 12 inches long by maybe 5 or 6 inches wide. It comes off. Their are relays under it. ... 1999 Ford Expedition

Need to change serpetine belt and power steering belt in a 2003 chrysler sebring coupe, is this an easy task? I cant see down in engine compartment because of limited space. If I could find a diagram of the layout. I could determine where to start as for bolt locations and piviot points. Any info. I would thank you. Dave


Tight spaces make it difficult to change, it would be worth the money to have a quick lube do it for you. ... 2003 Chrysler Sebring

Audi 100 1993, ok but how do i put the tranni fluid back in, i cant find were to put it, and the owners manual says i need to take it in to have a professional do it, this car is different from any other car that ive put tranny fluid in, theres no dipp stick or resevoir, and i want to do it myself


If you can't find a dipstick then you probably have to put the fluid back directly into the tranny pan.  There should be a second plug that sits higher up that you take out and then get some sort of pump or tube so you can fill it back up.   ... 1993 Audi 100

HELP cant take off power steering pump, I located two bolts in front of the p/s pump and took them off, I cant find any more in front of the pump from top view, could there be more bolts under or on back of the pump? do I need to get under the van to be able to remove the pump? I really need to remove the p/s pump so I can replace the broken pulley


There is a nut on the back of the pump near the top. It may be accessible from the top if you have long thin arms and a fairly short wrench (15mm, I think) There is a stud on the back of the pump that goes through the bracket and the nut goes on tha ... Plymouth Grand Voyager

99 Grandeur xg - speedo drops back to zero spasmodically, returns to normal by decelleration been happening about 2 years. Now auto transmission drops from 5th into 3rd gear (get home mode)at speeds ranging 60kmh to 100kmh, spasmodically. Returns to normal by stopping, switching off & restarting. Dealer says elec fault but cant help & to see Auto elec. Auto elec says could take very long time to find fault.


I'm no expert but I would venture a guess that you have to look in 3 areas. First is the connections/wirings between the transmission, sensors and computer box. There has to be a fault somewhere, if your computer checks out ok then it has to be a f ... Hyundai XG300

I have a 1999 saturn sl it has 130000 miles it runs good the check engine light came on with code po113 had it check at auto zone it says air intake temp circut it runs good but when i reach 50 on the highway the steering wheel just shakes a little nothing major when i turn on the car in the moring the sterring wheel shakes a little it says sensor open or shorted replace sensor i cant find that sensor can you please tell me where it is in a pitcher where its located and if i can replace it mysel


1st the sensor is part of the sensor array for the engine's fuel injection system and has nothing to do with the front end, that sounds like u have worn front end parts like tie rod ends or worn Constant ... Saturn SL

Computer I cant find the computer plug in to find out what is wrong with my 91 mazda 626, i have looked under the steering wheel where most are but it is not there, please let me know where it could be please or if possible the exact location.


It is under the hood on the drivers side near the shock tower ... 1991 Mazda 626

Blown head gasket, replaced and now cant time. all books and web say that the vehical is not timeable it has to be done by a comp. tech 2. but we went to dealer and their tech 2 couldn't read it. i cant seem to find out what its timing should be set at, like tdc or 2-6-10 btdc or atdc. dont know where to start before we drop the distributor in. we have tried it at 2 btdc and got the distributor in and it runs but has a miss to it. if we turn the distributor a little there is not much change and


The ignition timing is not adjusted with a timing light or with the engine running, and to set the ignition timing follow these procedures.There is a mark or notch on the distributor housing that the rotor should be pointing to when ... 1999 Chevrolet Silverado 1500

I have a 1998 chevy 1500 Z-71 pickup, and my steering wheel is really loose and i cant find my book to my truck, but i want to tighten my steering wheel, how do i do that?


Are you talking the steering play or looseness in the column ... 1998 Chevrolet K1500

Cant find fuse box at drivers left knee as it says in the book


According to internet research, the fuse box is above the foot rest to the left of the brake pedal. There should be a black plastic box or panel with the fuse box printed in white. You may have to remove two screws to access it. ... 2006 Suzuki Grand Vitara

Cant find reservoir to fill power steering fluid, not where manual says...


The power steering reservoir is under the altnator and idler pully on the bottom near the fire wall...this is by far the stupidest place every to put such a thing!!!! ... 2003 Chevrolet Impala

Strange vibrations I have a '99 Civic LX 4dr/sdn and noticed a hard vibration felt in the steering wheel. I can be felt driving at high speeds 50+ (not saying its not there at lower speeds, but can be felt at higher speeds). Put on 4 new tires and no change. Tranny checked out ok. Even looked for a bad wheel bearing and nothing. Had front end rebuilt prior to this about 4 years ago so o don't think i have worn bushings or a bad tierod. What could this possibly be? Any and all help is appreciated


The brake discs may be slightly warped. ... 1999 Honda Civic

I cant find the lever to open my bonnet .its not under the steering column where the manual says it is. we recently had dual controls fitted, is there another way to open the bonnet? Its a peugeot 1007.


Because the manuals are for lhd (left hand drive the manual is backwards the bonnet release is under the glove box on the passinger side. ... 2006 Peugeot 405

I can't find the reset button my book says I have to push because my explorer was in a fender bender. Looked under the carpet on the right side of the "hump" but couldn't see it. Do you have a schematic I could look at?


It is mounted on the firewall on the right side. You may have to remove the kickplate to see it...but it you are looking under the carpet you are in the wrong place. Enter the right side on the floor, look up and forward towards the firewall and you ... 1992 Ford Explorer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.8860 seconds