Having problems with your 1988 Chrysler LeBaron ?

May i be able to change my timing belt on my 88 chrysler lebaron my self

Posted / edited by AnonymousUser on : 17-12-2018

Answers :

You can but don't bite off more than you can chew!....The usual way to go about the job is to remove the front end belts...Alternator, steering pump and AC and then the cover for the timing belt....You'll need a puller to remove the crank shaft pully. Once that has been done set the engine on the timing marks provided for the job, Each of the pullies will have a mark and a corresponing pointer on the block or cylinder head....Locate those before you dismantle further....You should find them easily once the engine is on timing, usually at TDC and then loosen of the tensioner bearing so that it leaves the belt loose....the belt will then be able to be removed. Don't crimp or bend the new one and then make sure it goes on without being to difficult...If its tight maybe you haven't pushed the tensioner bearing far enough?....Make sure the timing marks match on all those of the marked pullies exactly....Half a tooth out is far too much!....Once you have everything matched, gently allow the tensioner to contact the belt and then check the marks again....Loosen the tensioner lock bolt half or three quarters of a turn and if you don't have a tension guage, have a friend turn the engine very slowly in the correct direction and allow the bearing to take up the correct tension while its being turned and then as its turning tighten the tensioner bearing lock bolt....If all marks still match, lock the tensioner and then rotate the engine by hand in the correct direction at least four times....If you come to any place where the rotation is inhibited stop at once. Never force rotation, as especialy with some vehicles you may damage valves and pistons....You'll find that the timing marks must be out of ailignment....Start the whole fitting procedure afresh....The only resistance should be the compression of the engine....Check the timing marks every second rotation of the engine....If all is well and the marks match exactly, Once your satisfied with all marks and the rotation and you've checked that every thing is tightened and locked properly, you can go ahead and re assemble in the reverse order to the one used during stripping....Its more difficult than it looks though and do you want that bigger chunk and are you that hungry?....Regards Johngee
Repair Help & Product Troubleshooting for 1988 Chrysler LeBaron

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0051 seconds