Having problems with your 1989 Ford Mustang ?

Ruptured gas line near gas tank

\015 Car wouldn't start, crank but no start, smelled gas, found gas squirting on to the rear axle houseing when key was turn on, couldn't get all the way under the car at time, how do I repair it.\015 Posted / edited by AnonymousUser on : 21-01-2019

Answers :

If your engine is fuel injected, I recommend that you cut back the rusted area 'till you reach a relatively clean straight section, then install a new section of steel line using brass compression fittings made for this purpose. If you have a mechanical pump, (non-fi) You can just cut the line and slide a section of rubber hose on there and clamp it at both ends. Make sure either repair is properly supported and clear of any moving parts (don't forget rear end goes up and down) to avoid future failure of the repair. Note: hose can be used to make a temp repair to get it off the road, but higher pressures made by electric pumps can cause hose to work it's way off if left in place.
Repair Help & Product Troubleshooting for 1989 Ford Mustang

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0051 seconds