Having problems with your 1989 Jeep Wrangler ?

89 wrangler just repl clutch slave then jeep wont start acts like dead bat. checked bat,fine. repl starter,cleaned contacts. just clicks like bad bat. will start with a push. guage looks good too while running.

Posted / edited by AnonymousUser on : 18-02-2019

Answers :

These were not made with a safety switch on the clutch, but far as the starting issue. I am expierencing the same thing. Replaced the clutch put it back together and it wont start. when I jump the starter by placing a jumper wire across the two starter posts it starts right up. acts like there is a switch or relay somewhere that is not allowing current to get to the starter.
There should be a sloenoid on the firewall it could be bad
Repair Help & Product Troubleshooting for 1989 Jeep Wrangler

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0100 seconds