Having problems with your 1990 Ford Probe ?

1990 probe won't start

\015 Everything works but the car will not turn over. had it towed to a shop and the machanic came out and started it right up! that was two weeks ago. this morning it wouldn't start again. help.\015 Posted / edited by AnonymousUser on : 19-11-2018

Answers :

Hi, sounds as if your imobiliser control is doing the usuall PROBE trick,it is located under the dash below heater controls, you cant miss it its black plastic and is retained by a silver bracket which is fixed by 2 rivets one side and 2 star drive screws on the other,cut or drill rivets out,unscrew other side,remove retaining plate from drivers side turn it over,unplug unit and remove 3 retaining screws,turn imobiliser unit over remove 3 screws in the plastic case, remove circit board and check solder points on the rear,odds are you will find 3 pins that need resoldering, resolder these and unit will be fine. TAKE CARE NOT TO LET SOLDER STRAY OR CONTAMINATE OTHER TERMINALS.
\015\012 Hope this helps you out,All the best,Phil
Repair Help & Product Troubleshooting for 1990 Ford Probe

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0083 seconds