Having problems with your 1991 Honda Accord ?

1991 Honda Accord Miss-fires dies

\015 Recently, this car would start and idle fast until warmed up and then hunt for the idle. It has begun to missfire while warming up and then it hunts, misses and dies. It has a new distributor, plugs, wires, injectors, pressure regulator, swapped ecu, cleaned isc valves, new tps and timing belt. Running out of ideas and money trying to get this licked. When it runs it runs very good and strong. Compression was good and fuel pressure was 45psi.\015 Posted / edited by AnonymousUser on : 14-05-2018

Answers :

I would try replacing the ignition control module and the distributor pickup as the next most likely cause of this problem. Also I would do the following
\012

This problem\012can be caused by a dirty automatic idle speed control valve and\012throttle valve. Buy a can of throttle valve cleaner from NAPA or\012Carquest (made by CRC chemicals) and spray it into the air intake\012while the engine is running, use up about 1/2 the can, engine will\012try to stall hold the speed up, shut it down and let it soak for 30\012minutes, restart and blow out the remaining fluid, shut it down and\012disconnect the negative battery cable for 5 Min's to reset the base\012idle control
\012



Repair Help & Product Troubleshooting for 1991 Honda Accord

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0052 seconds