Having problems with your 1991 Jeep Cherokee Limited ?

91 jeep cherokee want start

\015 I changed out the flywheel and the senor that goes with it, now it will not start. It will turn over and try to start but that is about it. It has gas and is getting gas. At one time the car had a alarm and someone said that when the computer was unplug that could be it. This is the only car my wife and I have to get to work. Please any help would be so grateful. Thank you very much.\015 Posted / edited by AnonymousUser on : 22-07-2019

Answers :

Check the wiring to the crank sensor sometimes the wires under the rubber boot breaks on the engine harness side, pull back the rubber and see, you should check for spark if you have none then it is something to do with the crank sensor, did you check the new flywheel for a pickup spot for the sensor? or possibly a dowel pin that should have been transferred to the new flywheel and wasnt? sometimes also there is a procedure to set an air gap between the pickup point on the flywheel and the crank sensor this is very important there mabye shims or an oblonged bolt hole in the sensor please rate -Jeff
Repair Help & Product Troubleshooting for 1991 Jeep Cherokee Limited

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0088 seconds