Having problems with your 1992 Oldsmobile Ninety Eight ?

Replace fuel filter

\015 How do i replace fuel filter\015 Posted / edited by AnonymousUser on : 12-04-2021

Answers :

The fuel filter is located near the rear of the vehicle, forward or rearward of the fuel tank, depending upon application. There is no service interval for fuel filter replacement. The filter only is replaced if it becomes restricted.
\015\012\015\012
REMOVAL & INSTALLATION\015\012Relieve the fuel system pressure at the shrader valve on the fuel rail. For details regarding this procedure, please refer to Fuel System of this information.
\015\012\015\012
    \015\012 \015\012
  1. If not done already, disconnect the negative battery cable.
  2. \015\012 \015\012
  3. Raise and safely support the vehicle.
  4. \015\012 \015\012
  5. Clean both fuel feed pipe connections and the surrounding areas at the in-line fuel filter with a clean rag to avoid possible contamination of the fuel system.
  6. \015\012 \015\012
  7. Using a backup wrench, remove the fuel line fittings from the fuel filter. Most of the models fuel gilter wrench sizes will be 16mm and 20mm.
  8. \015\012
  9. Either disconnect the quick-connect fittings by pushing inward toward the filter and grasping the plastic tab around the connector and pull them apart. Or remove the fuel filter mounting screws, then remove the filter from the vehicle.
  10. \015\012
  11. Discard the fuel line O-rings and replace with new ones during installation.
\015\012To install:

\015\012Install new O-rings to the fuel line fittings.
\015\012Connect the fuel lines to the fuel filter.
\015\012Position the filter in the same position it was during removal. Using a backup wrench, tighten the fuel lines to 20-22 ft. lbs. (27-30 Nm).
\015\012
    \015\012
  1. Install the fuel filter mounting screws if used.
  2. \015\012
  3. Lower the vehicle. Install or tighten the fuel filler cap, then connect the negative battery cable.
  4. \015\012
  5. \015\012Start the engine and check for leaks. Turn the ignition switch to the ON position for two seconds.Turn the ignition to the OFF position for ten seconds. Turn the ignition to the ON position. Check for leaks.
  6. \015\012
  7. \015\012
39cf52a.jpg
Repair Help & Product Troubleshooting for 1992 Oldsmobile Ninety Eight

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0083 seconds