Having problems with your 1993 Mercury Sable ?

How to remove starter from 1993 mercury sable

Posted / edited by AnonymousUser on : 18-03-2019

Answers :

Disconnect the battery cables. Locate the starter and disconnect the wiring. Next remove the mounting bolts. You may then remove the old starter. All this sounds easy, and it is, the only difficult part is accessing the starter. It is not easy to get to the bolts and you will likey have to do some feeling around and knuckle busting. But be patient, take your time and you should be able to pull off this repair. Good luck. I hope you find this to be very helpful.
Before removing the starter for repair or replacement, check the condition of all circuit wiring for damage. Inspect all connections to the starter motor, relay, ignition switch, and battery, including all ground connections. Clean and tighten all connections as seen fit.

Also keep in mind that the heavy gague input lead to the starter\015\012solenoid is hot at all times. Be careful to ensure the protective cap is installed over the terminal and replaced after service. \015\012
1. Disconnect the negative battery cable.

Note: When the battery has been disconnected and reconnected, some abnormal driveablilty symptoms may occur while the PCM relearns its adaptive strategy. It usually take about 10 miles of driving to relearn it, so take it easy.

2. Raise and safely support the vehicle.

3. Disengage the starter cable and the push-on connector from the starter solenoid.

4. Remove the upper and lower retaining bolts, then remove the starter motor from the vehicle.

5. Position the starter motor to the engine , then install the upper and lower retaining bolts finger tight.

6. Tighten the retaining bolts to 15-20 ft. pounds.

7. Engage the starter solenoid connector, making sure to push straight on until it locks into position, you will hear it click.

8. Install the starter calbe nut to the starter solenoid B terminal. Tighten the nut to 80-120 in. pounds, then install the red starter solenoid safety cap.

9. Lower the vehicle, then connect the negative battery cable.
Repair Help & Product Troubleshooting for 1993 Mercury Sable

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0052 seconds