Having problems with your 1994 Ford Bronco ?

Weak spark + 1988 ford bronco

\015 I have an 88/89 ford bronco with a 351 windsor. I recently replaced all the gaskets, flywheel, a new rotor and cap on the distributor, spark plug wires, and plugs, electronic control module, and now i am getting very weak spark and it will not start. What could be the cause of this? thanks\015 Posted / edited by AnonymousUser on : 06-07-2020

Answers :

I have an 89 ford bronco if i drive it to work get home shut it off try to start it again it wont start sounds like the battery is dead but have replaced the battery what could it be
Check the voltage of the b+ terminal of the ignition coil (primary side) with a cheap multimeter while cranking. low voltage to the primary will cause low voltage on the secondary. also recheck all ground paths from the ignition module. ensure good connection from coil to module. note: new parts are not "known good parts" until it runs.--> IG.MOD.
Repair Help & Product Troubleshooting for 1994 Ford Bronco

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0091 seconds