Having problems with your 1995 Honda Civic ?

How too put in distributor for a 1995 honda civic

Posted / edited by AnonymousUser on : 10-12-2018

Answers :

Hi man the Honda 92 to 95 has the same specs with little differents so try to go to this web \015\012
\015\012http://www.1993-honda-civic.com/category/radiator/\015\012
\015\012and u will find any thing u want about Honda Civic 1993 which is the sam as 1995 so try it hope it will work buddy
If you don't know what Distributor terminal is for #1cylinder
Disconnect the battery, for safety. Take out all the spark plugs. put a ratchet and socket on the crank pulley. This is to turn the engine \302\240over manually. You need to find when the #1 cylinder's piston is at it's highest point.\302\240\302\240(cylinder #1 is at the front of the engine, front of the engine is the end with the belts and alternator, not the end with the transmission) To do this take a long screwdriver and insert it down the #1 cylinder spark plug hole. Now turn the rachet slowly and watch as the screwdriver rises and falls with the piston. You need to get the screwdriver and piston at its highest point to find top dead center or TDC. when you have done this you now need to check if the engine is on it's compression stroke. Do this by looking for a clear line inset into the crank pulley and a line or pointer on the front (closest to your drivers side wheel) of the engine or timing cover plastic case. If the lines are lined up exactly and #1 piston is at its highest point, you have found top dead center on the compression stroke. Now you need to install the distributor as mentioned, and look at where the rotor is is pointing. Run a plug wire from that terminal to #1 cylinder. Then run the rest of your wires. Remember: #1 cylinder is closest to the drivers side wheel, followed by the rest in order to the passenger side. A 92-95 1.5 sohc 16v non vtec (d15b7) Honda civic firing order is 1342. start at the first terminal that you have just found on the distributor and hooked up to the # 1 cylinder. now hook a plug wire onto the next terminal (clockwise) and run it to cylinder #3, \302\240hook the next terminal to cylinder #4, next to #2 and your done. Hope my writeup helps, I did this a few weeks ago and it worked.
Repair Help & Product Troubleshooting for 1995 Honda Civic

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0094 seconds