Having problems with your 1995 Land Rover Range Rover ?
95 range rover good battery starter working but will not turn over?
\015 I have got a new battery stright wired the starter and both r working fine. ems fuse was blown in fuse box under hood replaced it but when i put the key in and tried to start fuse blew out help.\015
Ugh.... Goes without saying, you have a short somewhere, aka Rover Electrical Gremlin. Could be anywhere in the chain of ignition components. The one and only similar experience I've had led me to the starter. The way that it is positioned and the contact nuts being so close to the body that I believe the full power of the battery supply has enough current to jump this bridge of as little as. 4-5mm and cause an arc. (From the factory the starter comes with a protective rubber boot to prevent this.) Crawl under there (after disconnecting the battery) loosen the nuts on the posts of the starter and tighten them down after you position them in such a way that the cable and any metal on the connector or wire is as far from other metal of the body. If your preotective boot is gone then you need to insulate the positive contact somehow. Tape isn't going to do it, but liquid electrical tape will work or the rubber boot off of an old set of ignition wires could be modified with a bit of enginuity. Remeber to disconnect the negative lead off of the battery before doing ANY electric troubleshooting on a Rover. If by chance you were working on your starter and did not do this, you're in luck, a wrench to the live starter will blow a fuse everytime and this is where your problem would likely be. Good luck, hope this helps. Repost any additional info or questions and ill do my best to help
Repair Help & Product Troubleshooting for 1995 Land Rover Range Rover
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.