Having problems with your 1996 Ford Taurus ?

Stablizer sway bar link

\015 Ball joint is broken (boot sleeve is torn) need find propper instructions for removal and installation to fix this problem\015 Posted / edited by AnonymousUser on : 18-11-2019

Answers :

Remove the front wheel. Loosen the jam nut on the tie rod using pliers and wrench with lots of Liquid Wrench or other penetration oil. Back off the jam nut and mark the position of the tie rod end on the tie rod threads with paint.
\015\012Remove the cotter pin from the ballstud and then loosen the nut. Again more Liquid Wrench may be helpful. Now place the puller (special tool from auto parts store or Sears Craftsman) over the steering knuckle and separate the tie rod end from the knuckle. Fully remove the nut and then turn the tie rod end off the tie rod.
\015\012Installation is just the reverse with the new tie rod end turned on the tie rod up to the paint mark. Tighten the jam nut up to the tie rod end. Secure the tie rod end to the steering knuckle with the nut with a torque of 35 to 46 ft-lbs and insert a new cotter pin. Don't forget to reinstall the front wheel. Checking the front end alignment is recommended. Do not get the more expensive four wheel alignment as they cannot make any adjustment to align the rear wheels. ps Buy at least the Haynes Repair Manual for your car or splurge and buy the Ford complete repair manual.
Repair Help & Product Troubleshooting for 1996 Ford Taurus

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0088 seconds