Having problems with your 1998 Chevrolet Blazer ?

Can see antifreeze leaking down over four wheel drive unit

Posted / edited by AnonymousUser on : 03-08-2020

Answers :

This can be a couple of different things. firt open the hodd and then start the truck, Keep away from the fan make sure you are not wearing any loose clothing. The waterpump has a wheep hole on it when the berings are giveing out in the pump it will push water threw the weep hole where most of the time down the block onto the transfer case......Other wise look for water comming out of top and bottom raditior hose...If it is a pump this is how to fix it..
\012
\0121)Drain the coolant.

2)Remove the shroud: 7 - 10mm bolts

3)Remove the fan and clutch: There is no need to separate the fan from the clutch. The whole thing threads on to the end of the water pump. Turning counterclockwise removes the fan, clockwise tightens it back on (from the point of view of standing at the front of the vehicle facing the engine compartment). I don't know the size, because rather than break out all my wrenches, I just grabbed an 18 inch crescent wrench. Place the wrench on the nut and tap loose with a hammer. The tapping will break it loose. You have to tap it, if you just try to loosen it, the belt won't hold it and the whole thing will turn. After it breaks loose just spin it off.

4)Break loose the bolts holding the pulley on: 4- 13 mm or 1/2" bolts. Just break them loose, don't remove them.

5) Remove the serpentine belt.

6) Remove the pulley: Finish removing the bolts holding the pulley and remove the pulley.

7) Disconnect the hoses.

8) Remove the old pump: 4-14 mm or 9/16" bolts.

9) Clean the surface: Remove all traces of the old gasket.

10) Install new pump: Apply a bead of blue Permatex around the holes on both sides of the gaskets, put them on the pump and insert the bolts through the holes to hold the gaskets in place. Carefully lower the pump in to position. Thread the bolts into the block and snug them. Then remove the bolts one at a time, add the permatex to the threads, and then reinsert. (only do one at a time so that the pump doesn't shift and disturb the mating surfaces) Then tighten all the bolts.

11) Reinstall everything in reverse.

There will be a lot of air trapped in the system, so after you fill it, get the engine to operating temperature, shut it off, let it cool, then add more. The air trapped in the system can cause your engine to over heat if left unattended.
Repair Help & Product Troubleshooting for 1998 Chevrolet Blazer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0052 seconds