Having problems with your 1999 BMW 318 ti ?

Rear wiper linkge BMWe46 touring 2003 year

\015 My rear wiper is so stiff that the motor will not make the wiper sweep across the rear window.Dose any one no how to take the wiper post out of the rear screen so i can free it up or fit new one? thanks for any help.\015 Posted / edited by AnonymousUser on : 15-10-2018

Answers :

Try graphite lubricant in spray can spray in side boot ware shaft comes out.most have a c clip be hind wiper blade to replace it.try spraying it to free it up .
Not sure about this exact car but 99% of all wiper motors are retained with a nut ythart lives under the base of the wiper arm and with three or 4 nuts from the rear of the motor. Take the wiper arm off, possibly requiring the use of a 10 mm wrench, and you will see a large nut, remove this. See if the wioper mote is accessed from the trunk, most likly under a clip in panal, split the electrical connector and remove the nuts holding the motor on. You will see that the collar that had the nut accessed from above will be stiff to move on the wiper shaft. Work it off, scotch brite the shaft, run a small wire brush down the typically plastic tube, lube the shaft with chassis grease or white grease, check that it moves freely in the collar and reassemble
\015\012
\015\012good luck
Repair Help & Product Troubleshooting for 1999 BMW 318 ti

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0053 seconds