Having problems with your 1999 Isuzu Trooper ?

Where is Rail Oil Presure Sensor

\015 My car have some problem which compared of other placed are the samepls let me know where i can find the Rail Oil Presure Sensor to check\015 Posted / edited by AnonymousUser on : 26-10-2020

Answers :

Thats no help at all ! You will have a hard job to get the inlet manifold off on the 3.0 diesel ,the rail oil pressure sensor is inside the camcover its not the same item as a oil light or oil gauge sensor.
\015\012\015\012Disconnect the negative battery cable.
\015\012Remove the intake manifold.
\015\012Disconnect the oil pressure sensor electrical connector.
\015\012Using oil pressure socket remove the oil pressure sensor.-
\015\012that one is the more time consuming one to do- intake manifold comes off to reach it. Below are directions to replace it:intake manifold: NOTE The intake manifold, throttle body, fuel rail and injectors can be removed as an assembly. If you are not servicing these components individually, remove the intake manifold as a complete assembly.
\015\0121. Before servicing the vehicle, refer to the Precautions section.
\015\0122. Properly relieve the fuel system pressure.
\015\0123. Disconnect the negative battery cable.
\015\0124. Drain the engine cooling system.
\015\0125. Remove or disconnect the following: Air cleaner outlet duct A/C compressor pressure switch electrical connector Harness clip from the cylinder head and fuel raid Mass Airflow/Intake Air Temperature sensor connector
\015\0126. Disconnect the electrical connectorsfrom the following:
\015\0121. Main coil (2. Electronic Throttle Control (ETC)(3. Fuel injectors. Matchmark the connectors, pull the Connector Position Assurance (CPA) retainer up 1 click. Push the tab on the connector in, then detach the injector connector.
\015\012Alternator connector Evaporative emission (EVAP) purge solenoid electrical connector Knock Sensor (KS) electrical connector Main coil Fuel injector electrical connector Electrical harness clips from the fuel rail KS harness electrical connector from the intake manifold Positive Crankcase Ventilation (PCV) valve hose and valve Heater water shutoff valve actuator inlet hose from the intake manifold EVAP purge solenoid vent tube Vacuum brake booster hose from the rear of the intake manifold Upper engine wire harness retainer nut. Position the wire harness aside. Intake manifold bolts Intake manifold and gaskets. Discard the gaskets.
\015\012This will help. Thanks please keep updated.please do rate the solution positively .thank you for using fixya
Repair Help & Product Troubleshooting for 1999 Isuzu Trooper

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0052 seconds