Having problems with your 1999 Lexus ES 300 ?

Need description of obd drive cycle - 1999 Lexus ES 300

Posted / edited by AnonymousUser on : 13-08-2018

Answers :

This is my drive cycle a generic drive cycle i have used many times over the years and it has never failed me most drive cycles are too specific and impossible to adhere to for most drivers follow these steps exactly 1. make sure all codes are cleared and no check engine light is on 2 make sure the fuel level is between 1/4 and 3/4 full (this is part of the enable criteria for the evap monitor to run ) 3 let vehicle set overnight 4 start engine and let idle until the temp gauge is in the middle (this cold start enables the evap monitor and runs the O2 sensor heater test )5 drive vehicle around town avoid the highway stay at below 50 mph and when stoping at lights remove your foot from the gas and coast from around 50 to about 10mph or less if possible this will run the EGR monitor after about 3 to five miles of this proceed to the highway or freeway and travel over 50 but under 70 mph for about 3 to 5 miles this will run the catalyst test provided the O2 monitors passed if they didnt you will have a check engine light on before this point also i do a coast down on exit ramps (no braking) they make great places to get that EGR to run ONCE YOU START THIS PROCEDURE DO NOT KILL THE ENGINE OR SOME OF THE TEST WILL FAIL TO RUN
Repair Help & Product Troubleshooting for 1999 Lexus ES 300

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0080 seconds