Having problems with your 2000 Jeep Cherokee ?

How do you change the tps on a 2000 jeep grand 4.7

\015 How do you change the tps on a 2000 jeep grand cherokee 4.7\015 Posted / edited by AnonymousUser on : 10-12-2018

Answers :

The exact placement of the throttle position sensor generally is located on the side of the throttle\015\012body below the air intake tube on top of the engine.

To replace simply remove the air intake duct (usually one plastic\015\012screw), locate the sensor, disconnect wire plug in, remove the two\015\012sensor mounting screws (torx screw variety, size not remembered) and\015\012the sensor will come off. When replacing be sure to line up the\015\012throttle shaft with the proper groove inside the sensor...it should\015\012just slip in there pretty easily with a little bit of wiggling.\015\012Reinstall doing the reverse of the above.

Take's about 5 - 10 min to replace from start to finish and remember to clean the throttle body before starting this job to ensure no dirt will enter the engine. Good luck, Merry Xmass
Repair Help & Product Troubleshooting for 2000 Jeep Cherokee

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0052 seconds