Having problems with your 2000 Lexus ES 300 ?

2000 lexuses300 car turns off

\015 Every time i turn the car on it turns off i have to keep my foot on the gas peddle for it to stay on and the check engine light is not turn on\015 Posted / edited by AnonymousUser on : 20-06-2022

Answers :

I also have a 2000 ES300 and I had the same problem where it would idle so low to the point of stalling and sometimes it would and one time I was stranded while it did the very thing you described, it would start and then immediately shut off. This went on for 30 minutes before I finally got out of there. The idle air control valve attached to the front bottom of the throttle body against the firewall is the problem. However you do not need to replace it you can just clean it. After so many miles it becomes dirty and clogged. Only seems to be an issue on 2000 and 2001 vehicles with the Twin Throttle body. To fix remove the rubber throttle body hose closest to the firewall( if standing facing the driver side fender its the throttle body on the right hand side) once you remove the hose you'll see a hole in the bottom of the front part of the throttle body. Obtain a can of throttle body/air intake cleaner and using the straw that comes with the can insert into the hole(you can use force, you'll feel the straw flex around a bend in the hole) and generously spray into hole repeatedly. I recommend using an air duster and straw inserting in hole to blow out excess dirty fluid in between and than spraying cleaner again into hole moving straw in and out going deep as you can go with the straw. (normally about an inch or so) Be generous with the amount used. After your finished leave the last dose of fluid in the hole to flush through when you start the car.Reconnect hose, tighten screw clamp, start car, and go drive for a mile or so.I had to use about 1/4 of the can to clean. If you notice the problem returning repeat the procedure. I had to do this about twice before the problem stopped reoccurring. This will NOT damage anything in your car. If the car wont start due to hydro-lock, DON'T panic. Just keep trying to start car pumping gas it WILL start and wont damage car. You might notice fumes and/or smoke coming from the tail pipe as well. This is also normal and will only last a few minutes or so depending on how dirty it was to begin with. If you like you can also use some Sea Foam Deep Creep. The product will be double to triple the price of the throttle body cleaner though.
You need to have a mechanic replace a sensor that went bad and has caused that to happen (idling control sensor) this happened to my 1999 ES and that solved the problem. I had this done at a Toyota dealer for about $300. Also check the battery terminals to ensure they are fastened tightly because this can also contribute to your issue
Repair Help & Product Troubleshooting for 2000 Lexus ES 300

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0056 seconds