Having problems with your 2001 Hyundai Elantra ?

IT IS NOT WORKING

\015 CAN I FIX THE MAP SENSOR FOR THE ELANTRA 2001\015 Posted / edited by AnonymousUser on : 18-06-2018

Answers :

Run this diagnostic\015\012\015\012\015\012
\015\012Test Procedures 
1. Check if DTC P0110 is set in addition to DTC P0105 or P0106. If DTC P0110 is set, go to next 
step. If DTC P0110 is not set, go to step 3 . 
2. Turn ignition off. Disconnect MAP sensor 4-pin connector. Measure resistance between ground 
and MAP sensor connector terminal No. 4 (Green wire). If resistance is one ohm or less, replace 
MAP sensor. If resistance is more than one ohm, repair open in Green wire between MAP sensor 
and ECM connector terminal No. 48. After repairs, clear DTC and verify MAP sensor operation. 
3. Turn ignition off. Disconnect MAP sensor 4-pin connector. Measure resistance between MAP 
sensor connector terminals No. 1 and 4 (component side). Resistance should be about 30,000 
ohms. If resistance is as specified, go to next step. If resistance is not as specified, replace MAP 
sensor. After repairs, clear DTC and verify MAP sensor operation. 
4. Turn ignition on. Measure voltage between ground and MAP sensor connector terminal No. 2 
(Red wire). Voltage should be about 5 volts. If voltage is as specified, go to next step. If voltage is 
not as specified, repair open in Red wire between ECM connector terminal no. 44 and MAP 
sensor connector terminal No. 2. After repairs, clear DTC and verify MAP sensor operation. 
5. Turn ignition off. Disconnect ECM 63-pin connector. Check for continuity between ground and 
MAP sensor connector terminal No. 1 (Green wire). If continuity does not exist, go to next step. If 
continuity exists, repair short to ground in Green wire between MAP sensor and ECM. After 
repairs, clear DTC and verify MAP sensor operation. 
6. Reconnect MAP sensor connector and ECM connector. Turn ignition on. Backprobe MAP sensor 
connector and measure voltage between ground and MAP sensor connector terminal No. 1 (Green 
wire). Voltage should be 0.2-4.5 volts. If voltage is as specified, go to next step. If voltage is not 
as specified, replace MAP sensor. After repairs, clear DTC and verify MAP sensor operation. 
7. Check ECM connector for loose or damaged terminals. If problem exists, repair ECM connector. 
If problem does not exist, replace MAP. Clear DTC and verify system operation. If problem still 
exists, replace ECM. After repairs, clear DTC and verify system operation.
\015\012
\015\012Good luck and hope this helps. If the car does not start diconnect the MAP sensor to get you to the parts store if you need it to get you there.
Repair Help & Product Troubleshooting for 2001 Hyundai Elantra

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0069 seconds