Having problems with your 2002 Jaguar X-Type ?

Thank you for your response , been going crazy here...got panel off enough to put hand in but don't know where to pull to unlock door.

Posted / edited by AnonymousUser on : 21-01-2019

Answers :


\015\012\015\012\011\011\011\011\015\012

Jaguar 2000-06 - Locks & Lock Systems
Power Door Locks - Removal & Installation

Door Lock Switch
Door Lock Diagnosis & Testing
\015\012\015\012

    \015\012
  1. \015\012Visually inspect the following:\015\012
    \015\012Misaligned door(s), hood or luggage compartment lid\015\012\015\012Door latches\015\012Actuating rod\015\012Exterior door handle\015\012Interior door handle\015\012Door lock cylinder\015\012Cable\015\012Luggage compartment lid exterior release switch\015\012Fuse(s)\015\012Wiring harness\015\012Electrical connector\015\012Door lock actuator\015\012Remote transmitter batteries\015\012Vehicle battery\015\012Remote transmitter\015\012Door lock switch\015\012Front electronic module\015\012\015\012\015\012\015\012
  2. \015\012 \015\012
  3. \015\012If an obvious cause for an observed or reported concern is found, \015\012correct the cause (if possible) before proceeding to the next step.\015\012
  4. \015\012
\015\012
\015\012Door Lock Motor
Coupe And Convertible
\015\012\015\012
    \015\012
  1. \015\012Turn ignition key to position II.\015\012
  2. \015\012
  3. \015\012Motor door glass to fully raised position.\015\012
  4. \015\012
  5. \015\012Turn ignition key to position O.\015\012
  6. \015\012
  7. \015\012Disconnect the negative battery cable.\015\012
  8. \015\012
  9. \015\012Remove door casing for access.\015\012
  10. \015\012
  11. \015\012Remove door water shedder.\015\012
  12. \015\012
  13. \015\012Position PVC secondary water shedder for access.\015\012
  14. \015\012
  15. \015\012Slacken and remove the door glass rear runner lower securing screws.\015\012
  16. \015\012
  17. \015\012Reposition door glass rear runner. Mark the position of the glass rear runner upper securing screw.\015\012
  18. \015\012
  19. \015\012Slacken and remove the upper securing screw and move the runner away from the glass.\015\012
  20. \015\012
  21. \015\012Disconnect door handle and lock barrel (driver door only) operating rods from latch links.\015\012
  22. \015\012
  23. \015\012Slacken and remove the three latch assembly securing screws and position latch for access.\015\012
  24. \015\012
  25. \015\012Remove latch motor harness multiplug from mounting bracket and disconnect multiplug.\015\012
  26. \015\012
  27. \015\012Release operating cable from door handle. Move inner door handle \015\012to the locked position. Remove operating cable outer abutment from \015\012support bracket. Disconnect cable inner from door inner handle.\015\012
  28. \015\012
  29. \015\012Remove lock motor assembly from door.\015\012
  30. \015\012
  31. \015\012To install, reverse removal procedure.\015\012
    \015\012
    \015\012\015\012\015\012zjlimited_378.jpg
    \015\012\015\012

    \015\012Fig. Removing door lock actuator
    \015\012\015\012

\015\012
\015\012Sedan
\015\012
    \015\012
  1. \015\012Remove the door window glass\015\012
  2. \015\012
  3. \015\012Detach the interior door handle.\015\012
  4. \015\012
  5. \015\012Detach the actuator remote cable from the interior door handle.\015\012
  6. \015\012
  7. \015\012Remove the interior door handle.\015\012
  8. \015\012
  9. \015\012Detach the door window glass run.\015\012
  10. \015\012
  11. \015\012Remove the exterior door handle retaining screws.\015\012
  12. \015\012
  13. \015\012Remove the front door actuator retaining screws.\015\012
  14. \015\012
  15. \015\012Reposition the front door actuator and exterior handle.\015\012
  16. \015\012
  17. \015\012Remove the front door actuator and exterior handle.\015\012
  18. \015\012
  19. \015\012Disconnect the front door actuator remote cable.\015\012
  20. \015\012
  21. \015\012Detach the door lock cylinder connecting rod (1).\015\012
  22. \015\012
  23. \015\012Detach the exterior door handle connecting rod (2).\015\012
  24. \015\012
  25. \015\012Remove the front door actuator (3).\015\012
  26. \015\012
  27. \015\012To install, reverse removal procedure.\015\012
    \015\012
    \015\012\015\012\015\012zjlimited_379.jpg
    \015\012\015\012

    \015\012Fig. Removing door lock motor-Sedan



Hope this helps.
Repair Help & Product Troubleshooting for 2002 Jaguar X-Type

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0098 seconds