Having problems with your 2002 Suzuki Esteem ?

Evap system Have P 0455. Found a hose from top of gas filler pipe is broke over top of gas tank. Can I find where it goes and replace w/o removing gas tank with another line?

Posted / edited by AnonymousUser on : 03-05-2021

Answers :

The FSM is clear on this. each hose and fitting must be air tight.
or the the car vents gas fumes full time, and the EVAP ECU tests
(monitor) make sure this all works.
you can just look at the left and right side above rear tires. and see
if your hands are small enough to fit here. Id bet not.
some mech, report, the tank can be tilted down at front (drained fuel)
and gain access.
keep in mind, you get fuel siphoning at any time. do not open the system, with fuel in the tank, and then drive to autozone,
i loosen the gas cap so that pressure can not build in tank.
expanding fuel can push fuel out , during a filter change. very
dangerous in a garage, and you gone.
it's just a vent hose, you can see, it and what needs to be done is really obvious. given you arms sides and lenght.
my fsm states, " TANK pull"

Removal & Installation

\012
  1. \012 Relieve the fuel system pressure and disconnect the negative battery cable.
    \012
  2. \012 Remove the fuel filler cap from the fuel tank.
    \012
  3. \012 Have a Class B fire extinguisher near the work area. Use a hand\012 operated pump device to drain as much fuel through the fuel filler neck\012 as possible.
    \012
  4. \012 Use a siphon to remove the remainder of the fuel in the tank by connecting the siphon to the fuel pump outlet fitting.
    \012 \012 \012 \012\011\011\011\011\011\011\011\011\011\011CAUTION\012\011\011\011\011\011\011\011\011\011\012 \012 \012 \012 Never drain or store fuel in an open container because there is the possibility of a fire or an explosion.
    \012 \012 \012 \012 \012
  5. \012 Reinstall the fuel filler cap.
    \012
  6. \012 Remove the rear seat cushion from vehicle (if so equipped).
    \012
  7. \012 Disconnect the fuel pump motor connector and sending unit electrical connectors.
    \012
  8. \012 Disconnect the wire harness grommet and harness through the vehicle floor pan.
    \012
  9. \012 Raise and safely support the vehicle.
    \012
  10. \012 Remove the fuel filler hose clamp from the filler neck assembly.
    \012
  11. \012 Remove the fuel breather hose clamp from the filler neck assembly.
    \012
  12. \012 Remove the fuel filter inlet hose clamp and hose from the filter.
    \012 \012 \012 \012\011\011\011\011\011\011\011\011\011\011NOTE\012\011\011\011\011\011\011\011\011\011\012 \012 \012 \012 A small amount of fuel may be \012released after the fuel hose is disconnected. In order to reduce the \012chance of personal injury, cover the fitting to be disconnected with a \012shop towel.
    \012 \012 \012 \012 \012
  13. \012 Remove the fuel vapor clamp and hose, and fuel return hose clamps and hose from the respective fuel lines.
    \012
  14. \012 Using a suitable transaxle jack, support the fuel tank.
    \012
  15. \012 Remove the fuel tank retaining bolts and lower the tank.
    \012
\012 To install:
\012
  1. \012 Reconnect all fuel hoses, lines and the fuel breather hose to the fuel tank.
    \012
  2. \012 Place the fuel tank in its proper space using the transaxle jack, Install the fuel tank retaining bolts.
    \012
  3. \012 Remove the transaxle jack.
    \012
  4. \012 Reconnect all fuel hoses, lines and the fuel breather hose to the fuel tank.
    \012
  5. \012 Install the fuel breather hose and hose clamp to the filler neck assembly.
    \012
  6. \012 Install the fuel vapor hose and hose clamps. Install the fuel return hose and hose clamp to the respective fuel lines.
    \012
  7. \012 Install the fuel filter inlet hose and hose clamp to the filter.
    \012
  8. \012 Lower the vehicle. Install the wire harness and grommet through the vehicle floor pan.
    \012
  9. \012 Connect the fuel pump motor and the sending unit connectors.
    \012
  10. \012 Install the rear seat cushion. Reconnect the negative battery cable.
    \012
"
Repair Help & Product Troubleshooting for 2002 Suzuki Esteem

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0054 seconds