Having problems with your 2002 Toyota Camry ?

How do i drain and flush my trany fluid

\015 How do u add more fluid?\015 Posted / edited by AnonymousUser on : 18-06-2018

Answers :

Hi, Get a good size oil pan because their isn't just a plug to remove. You have to take off the whole pan on the bottom of the tranny. There will be between 10 an 20 bolts holding it on. After removed you will see the filter it will be square or rectangular like shaped. Simply just pull it out from the tranny it just plugs in. You should change the filter along with the fluid and gasket. Be sure to remove all of old gasket. When putting back together use liquid gasket, put a little bit on your finger or small globs around the pan where the gasket will go. Do this before putting new gasket on. Spread thre liqiud gasket around where the gasket will go. After that lay the new gasket on top of the newly applied liquid gasket. This will help out considerably in keeping the gasket in place when putting the pan back on. Line up the pan hold in place with one hand and screw in a two or 3 bolts by hand, you just want to get them started so they will hold the pan up while putting in the rest. After all bolts are in tighen down alternating side to side end to end tighten firmly but do not over tighten, the tranny is aluminum and the threads will strip if over tightened. Filling the tranny you will need a transmission funnel, you can get them at wal-mart any parts store. It is a long thin funnel than goes directly into the dipstick tube and fill from there. Put in two quarts and then start the engine to check level. The car has to be runnig wlie you check the fluid level. I hope this helped you out. It would be greatly appreciated if you could rate my answer, Thanks. Good luck...... MIKE-
Repair Help & Product Troubleshooting for 2002 Toyota Camry

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0086 seconds