Having problems with your 2003 Ford E250 ?
2003 Ford E250 Remove/replace front brake pads
\015 How do you remove the old brake pads?\015
You will have to take the wheel off, then try to use a latge screw driver to pry between the old pads and the rotor to push the old pads back some, this will allow you to remove the caliper easier later. Next get a T-45 socket and remove both the top and bottom bolts from the back of the caliper. Tilt the brake caliper at the top or the bottom (it different for both side), and slide it off. Then you can just remove the pads. Be careful to notice that the shims on the caliper slide are different from top to bottom, don't mix them up. Pull the caliper slide pins out and inspect the boot for hole or cracks and the pins for rust, replace if any of these condition exist. Use some brake silicone grease to lube the slide pins and put a little into each boot and put the slide pins back in. Check the rubber boots on the caliper pistions to make sure they are not leaking any fluid or ripped. Use one of the old brake pads and a C-clamp to push both pistons on one caliper back in until they are flush. Check to make sure that no fluid leaked out of the caliper pistons while they were being pushed back in. If you want to do what is call a pad slap only then you can install that pads at this time but that is not recommended. It is recommened that you measure, check and turn the rotors if at all possible or replace them, the wheel seals and check and repack the wheel bearings.
Repair Help & Product Troubleshooting for 2003 Ford E250
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.