Having problems with your 2004 Nissan Quest ?

How to tighten belt on 2004 nissan quest

\015 How to tighten alternater belt on 2004 nissan quest\015 Posted / edited by AnonymousUser on : 20-08-2018

Answers :

Best to remove the front passenger side wheel. Then snap out the clips that are holding the plastic cover towards the front. Now it will expose the belt area. Loosen the locking nut of the tensioner(idler) pulley located to the right of the Crankshaft Pulley. Crankshaft pulley is the one that handles both belts (alternator and the power sterring pump). Right to that next to it, upwards is the idler pulley. You will find the alternator pulley to the right of that further up. Open the hood of the van and locate the adjusting nut behind the alternator on the idler pulley from top and loosen that as well. Once both these are loosened, belt will loosen and will be easy to remove. Now replace it with the new belt the same way it was wrapped. Go over the crankshaft pulley; under the A/C compressor pulley; over the alternator pulley; under the idler pulley. tighten the adjusting nut from the top through the hood until the play on the belt (when pressed in) is less than 1 inch. Now lock the tensioner pulley by tightening the locking nut. Start and run the car for 15 mins to see if everything is ok.
Repair Help & Product Troubleshooting for 2004 Nissan Quest

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0079 seconds