Having problems with your 2005 Lincoln LS ?

How to add transmission fluid to a 2005 lincoln LS

Posted / edited by AnonymousUser on : 08-08-2022

Answers :

H, yiour vehicle has no transmission dip stick, here is the procedure from Lincoln.

Use a OBDII scan equipment to monitor Transmission Fluid Temperature, start the vehicle and run engine at idle until fluid temperature is between 80\302\260 to 120\302\260 F (27\302\260 to 47\302\260C). Shift through gears slowly stopping in each gear allowing it to engage. Put in PARK position. With engine running put vehicle up on hoist level as possible. Hold the larger drain plug with a wrench and remove the small center plug. Allow the fluid to drain, making sure that the fluid is between 80\302\260 to 120\302\260 F (27\302\260 to 47\302\260C). If the fluid comes out as a thin stream or drip, the fluid is at the correct level. Reinstall the small center plug and tighten to 7 ft. lbs. (10 Nm).
\015\012\015\012\015\012
\015\012
\015\012You will need a special fitting available from Lincoln and screw it into where the fluid level indicator was. Add new transmission fluid to a suction gun, attach the gun to the fitting and add fluid in 1/2 pint increments, wait one minute, if the fluid comes out in a thin stream or drips the level is correct. If not add another 1/2 pint.
Repair Help & Product Troubleshooting for 2005 Lincoln LS

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0089 seconds