Having problems with your 2006 Chevrolet HHR ?

2006 hhr to take out ignition switch out - 2006 Chevrolet HHR

Posted / edited by AnonymousUser on : 12-04-2021

Answers :

Removal & Installation
\015\012
\015\0121. Disable the SIR system.
\015\012
\015\012
\015\01228d6a49.gif\015\012
\015\012Remove the Instrument Panel (I/P) center trim panel by releasing the retaining fasteners
\015\012
\015\012
    \015\012\015\012
  1. \015\012Remove the Instrument Panel (I/P) center trim panel (1) by pulling out on the trim panel in order to release the retaining fasteners (2).
  2. \015\012
  3. \015\012Disconnect the electrical connectors on the Instrument Panel (I/P) center trim panel (1).
\015\012
\015\012dc7f057.gif\015\012
\015\012Remove the steering column opening filler assembly, with clip, & bumper
\015\012
\015\012 3. Remove the steering column opening filler assembly (1) by pulling away the clips (2).
\015\012 4. Disconnect the electrical connector for the trunk release.
\015\012
\015\012
\015\01277e0f1d.gif\015\012
\015\012
\015\012Remove the Instrument Panel (I/P) left side trim panel
\015\012
\015\012
    \015\012\015\012
  1. \015\012Remove the Instrument Panel (I/P) left side trim panel (1).
  2. \015\012
  3. \015\012Tilt the steering wheel up.
    \015\012
  4. \015\012Disconnect the I/P dimmer switch and, if equipped, the fog lamp switch.
\015\012
\015\01288e8dec.gif\015\012
\015\012
\015\012Remove the 4 bezel screws (2) & the Instrument Panel (I/P) cluster bezel assembly (1)
\015\012
\015\012
    \015\012\015\012
  1. \015\012Tilt the steering wheel down.
  2. \015\012
  3. \015\012Remove the 4 instrument panel cluster bezel screws.
    \015\012
  4. \015\012Remove the instrument panel cluster bezel.
\015\012
\015\012810fe4a.gif\015\012
\015\012
\015\012Remove the steering column trim covers: steering column upper cover assembly, steering column left cover assembly, & steering column right cover assembly
\015\012
\015\012Remove the steering column trim covers:
\015\012
    \015\012
  • \015\012Remove the 3 cover screws (4).
    \015\012
  • \015\012Remove the steering column upper cover assembly (1).
    \015\012
  • \015\012Remove the steering column left cover assembly (2).
    \015\012
  • \015\012Remove the steering column right cover assembly (3).
\015\012
\015\012
\015\012bd6042a.gif\015\012
\015\012Removal of the ignition switch
\015\012
\015\012\015\012
  • \015\012
      \015\012
    1. Disconnect the ignition switch harness connector.
    \015\012\015\012\015\012\015\012\015\012\015\012
      \015\012
    1. WARNING
    \015\012\015\012\015\012The ignition switch must be in the run position during removal in order to avoid damage to the ignition switch.

  • \015\012
      \015\012
    1. \015\012Turn the ignition switch to the run position.
      \015\012
    2. \015\012Remove the ignition switch screws.
      \015\012
    3. \015\012Remove the ignition switch from the steering column.
    \015\012To install:
    \015\012
      \015\012
    1. \015\012Install the ignition switch and screws on to the steering column. Tighten the screws to 17 inch lbs. (2 Nm).
      \015\012
    2. \015\012Connect the ignition switch harness connector.
      \015\012
    3. \015\012Installation is the reverse of removal procedure.
      \015\012
    4. \015\012Tighten the trim cover screws to 17 inch lbs. (2 Nm)
      \015\012
    5. \015\012Tighten the 4 instrument panel cluster bezel screws to 19 inch lbs. (2 Nm)
      \015\012
    6. \015\012Enable the SIR system. Refer to Air Bag (Supplemental Restraint System), arming the system.
      \015\012\015\012\015\012\015\012\015\012NOTE \015\012\015\012\015\012If the ignition switch is replaced and a learn procedure is not performed, the engine will crank but not start or will start and stall immediately.

      \015\012
    7. \015\012Perform the vehicle theft deterrent system learn procedure.
    Repair Help & Product Troubleshooting for 2006 Chevrolet HHR

    Tips for a great answer:

    - Provide details, support with references or personal experience .
    - If you need clarification, ask it in the comment box .
    - It's 100% free, no registration required.

    Suggested Questions/Answers :

    Loading ...

    • Start your question with What, Why, How, When, etc. and end with a "?"
    • Be clear and specific
    • Use proper spelling and grammar
    all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
    Load time: 0.0075 seconds