Having problems with your 2006 Chevrolet Silverado ?

2006 chevy silverado heater fan dont work fuse ok

Posted / edited by AnonymousUser on : 03-10-2022

Answers :

Replace the blowermotor resistor, it is also called a blowermotor control processor its located on heater box next to the heatercore, here a picture of it and a diagram to show you exactly were it is. this will solve your problem,hope this helps you.daf0cd2.gifc3ee9b2.jpg
There may be one blower fuse under the hood, and one in the cab. The fuse in the interior may be labeled HVAC. If your sure all fuses are good use a dvm to check for power at the resistor and the blower. The resistor should be attached to the blower or very near it. The two wires going to th blower motor (after the resistor) should have 12v when fan speed selector is on high and key on. The voltage should vary relative to the fan speed selected. If you have voltage here the blower motor is bad. Usually the bearings are what go bad, you can remove the blower and wire it direct to the battery and it should work if you spin the fan by hand first to loosen it. Sometimes the motor burns out but if something is actually burnt the problem may be somewhere else, BCM, blower control module, resistor, or a short. Take it to a shop to diagnose if this is the case.
Repair Help & Product Troubleshooting for 2006 Chevrolet Silverado

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0086 seconds