Having problems with your 2006 Toyota Sienna ?

Changing the rear disk brakes on a 06 toyota sienna, what is the process?

Posted / edited by AnonymousUser on : 19-10-2020

Answers :

-Set up jack and properly block front tires.
\015\012
\015\012-Do not set parking break as this may hender removing the rear calipers. Open hood and remove the brake resevoir cap.
\015\012
\015\012-Remove hubcaps if applicable,
\015\012
\015\012-Loosen Lugnuts but do not remove,
\015\012
\015\012-Jack up van,
\015\012
\015\012-Remove tire.
\015\012
\015\012-Caliper should be visible. There are two bolts or hex heads on the back side that can be a pain to remove sometimes.
\015\012
\015\012-Pull the caliper off the rotor, It is recomended to have the rotors turned or replaced. With the old pad still in place, take a c clamp or brake caliper squeezer and compress the caliper
\015\012
\015\012-remove old pad, take note for the reinstall of the new pad.
\015\012
\015\012-reverse the steps. This is a simple break down. Hope it helps
Repair Help & Product Troubleshooting for 2006 Toyota Sienna

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0073 seconds