Having problems with your 2007 Volkswagen Jetta 2.5 Sedan ?

Where is the oil pump located on a 2007 Volkswagon Jetta

Posted / edited by AnonymousUser on : 17-09-2018

Answers :

Its located inside the engine there is an oil tank type under the engine with about 15 to 20 bolts this is called sump you have to remove it to get to the oil pum But dont try this at home its a technicians job
I looked on my online resource which is based on Chilton and found nothing about the oil pump on the 2007 VW Jetta 2.5 engine.
\015\012
\015\012I looked on Autozone.com and found nothing on the oil pump for the 2007 VW Jetta 2.5L engine.
\015\012
\015\012 You'll have to purchase a Chilton or Haynes manual to look it up, I thought.
\015\012
\015\012But, when I looked up the 2007 VW, it didn't list any VW models for the Haynes, site anyway.
\015\012
\015\012It did for 1997 VW, though. Hm.
\015\012
\015\012Maybe your vehicle is too new to have data available on it for the aftermarket.
\015\012
\015\012---
\015\012
\015\012NOTE
\015\012The instructions here for the installation of either type of pump are general. Specific installation directions, as well as oil priming instructions (if necessary), can be found in the service manual.\015\012In the case of a typical distributor-driven oil pump, the installation should be performed in the following manner:
\015\012f11-28.gif\015\012Installation of an oil pump driven by the distributor. Courtesy of General Motors Corporation-Chevrolet Motor Division. \015\012\015\012
    \015\012
  • Position the intermediate drive shaft into the distributor socket. \015\012
  • With the shaft firmly seated, the stop on the shaft should touch the roof of the crankcase. \015\012
  • Remove the shaft and position the stop as necessary. \015\012
  • With the stop properly positioned, insert the intermediate drive shaft into the oil pump. Install the pump and shaft as an assembly. \015\012
  • Do not attempt to force the pump into position if it will not seat readily. The drive shaft hex might be misaligned with the distributor shaft. \015\012
  • To align, rotate the intermediate drive shaft into a new position. \015\012
  • Tighten the oil pump attaching screws to torque specifications. \015\012
  • Clean and install the oil pump inlet tube and screen assembly.
\015\012The installation of a typical camshaft-driven oil pump is done as follows:
\015\012f11-29.gif\015\012Installation of an integral oil pump driven directly by the crankshaft. Courtesy of American Honda Motor Co., Inc. \015\012\015\012
    \015\012
  • Apply a suitable sealant to the pump and block. \015\012
  • Install the pump to its full depth and rotate it back and forth slightly to ensure proper positioning and alignment through the full surface of the pump and the block machined interface surfaces. \015\012
  • Once installed, tighten the bolts or screws. The pump must be held in a fully seated position while installing bolts or screws.
Repair Help & Product Troubleshooting for 2007 Volkswagen Jetta 2.5 Sedan

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0050 seconds