Having problems with your Land Rover Range Rover Sport ?

Soft brake pedel after fitting brake pads range rover 2006e

Posted / edited by AnonymousUser on : 22-10-2018

Answers :

Hopefully the hydrolic system was not opened when you were fitting, in which case all you need do is pump the brake pedal a few times to achieve correct pressure. If you did open the bleed nipples or worse, you'll have to bleed the system. This will require two people or even three. One person to keep the pot under the bonnet topped up, one inside pumping the brake pedal and the third under the vehicle....The meathod of bleeding is to pump the pedal at least four times and hold it down with the foot. The peson underneath opens the nipple and as the pressure releases pushdown with your foot untill you can't push further and hold it there, at which time you yell, close! The guy underneath closes the nipple and then you begin again. the guy under the bonnet should make sure that the resviour is topped up. Begin with the wheel furthest from the brake cylinder, in other words at the rear and finish with the closest. Cheers and Regards Johngee
Repair Help & Product Troubleshooting for Land Rover Range Rover Sport

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0095 seconds