Having problems with your Mitsubishi Galant ?

While driving 65 with the cruise on the transmission disengaged and will not work in any gear,coasted to a stop. Engine works fine,going to any gear will not shift to any automatic gear setting,. Checked all fuses all O K .

Posted / edited by AnonymousUser on : 27-09-2021

Answers :

Perhaps the linkage from the shifter to the transmission has become disconnected. If not that you may have transmission issues.

You may also need to detach the shifter from cable/rod that goes\015\012to transmission and check if there's anything that you need to repair/replace.

Check also the shift control solenoids. These solenoids are identified as "Shift Solenoid A" and "Shift Solenoid B". An automatic\015\012transmission or transaxle gets their different gears by applying\015\012hydraulic pressure to or releasing hydraulic pressure from the internal\015\012mechanisms that hold gear sets engaged. Hydraulic pressure is also used\015\012to apply or release the internal clutches for the gear sets and allows\015\012for the shifts between gears.The solenoids are electrically applied to\015\012block pressure lines and un-applied to open the line for pressure.\015\012Depending on which solenoids are enegized (blocking a passage) and\015\012de-energized (allowing pressure) there are four possible combinations\015\012of ways for SSA and SSB to allow fluid to flow (On-On; On-Off; Off-Off;\015\012and Off-On). Those combinations give you the separate gears in your\015\012automatic transmission based on the routing of fluid through the\015\012transmission's internal passage ways to the holding devices or gear\015\012sets. When a solenoid stops working you typically hear that the\015\012transmission isn't shifting into a gear.

Have a great day!
Hi,
\015\012
\015\012A low cost way to go first would be to try and change the trans fluids.
\015\012
\015\012The rotors have legal limits of thickness assigned to them by the Department of Transportation. If the rotors are too thin to be machined or have worn beyond the minimum spec, then the rotors need to be replaced. Most shops/mechanics will explain this, so I would ask your shop to do the same and show you the specs etc.
\015\012
\015\012Thanks for contacting Fixya
\015\012
Repair Help & Product Troubleshooting for Mitsubishi Galant

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0101 seconds