Having problems with your Toyota Camry ?

Removing dash of 2003 camry to replace radio

\015 Wanting to replace after market radio with original 2002 toyota radio\015 Posted / edited by AnonymousUser on : 10-12-2018

Answers :

If your dash has not been modified by whomever installed the aftermarket radio, it should go like this:

Using a flat screwdriver, gently pry the bottom edge of the air conditioner control assembly to disengage the clips (there are 6 of them). Pull the control assebly out and disconnect the electrical connectors and set aside.

Remove the 4 bolts on the lower edge of the radio finish panel located under where the air conditioner assembly was located. Pry around the edges of the radio finish panel to disengage the 5 clips (two on either side and one at the top center) The finish panel and radio assembly will then pull out of the dash so the electrical connectors can be disconnected and the radio removed (again, this is providing that no modifications have been made).

Hopefully, you will find the vehicle wiring harnesses and radio mountings still intact. Many times, aftermarket radio installers will cut and splice several of the wires from the original radio connectors, And modify the mountings to accomodate a radio that was not made to fit the vehicle, making it necessary to repair the wiring harnesses and/or mountings before an original-type radio can be reinstalled.
Repair Help & Product Troubleshooting for Toyota Camry

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0076 seconds