Having problems with your Volkswagen Golf ?

Change tranny fluid,now reverse gear not grabing,on flat ground i get some movement,but revs. up,like slipage,...more fld. or less perhaps? any suggestion.95 golf o1m trans.2L.

Posted / edited by AnonymousUser on : 26-10-2020

Answers :

The 01M needs to be hooked up to a scan tool (VAG 1552) then you'll also need VAG 1924 ATF filler kit or similar.
Procedure:
1) Address word 02- Transmission Electronics
2) Advance to read measuring value blocks -08
3) Select display group -05
4) Observe display field 1 for transmission temperature (must be below 30*C at start)
5) Lift vehicle
6) Place container under trans
7) Bring ATF to test temp (ATF Test temp 35 to 45*C (95 to 113*F)
8) Remove level plug from trans oil pan
9) If ATF drips out of hole when temp is bet 35* - 45*C ATF level is correct and no further action is required. Install new seal and level plug and torque. This completes the ATF check

note: If the ATF drips out the hole by the time the temp reaches 45*C, fill through the filler tube until fluid comes out of the level checking hole.
Make sure you have the exact fluid VW calls for, be careful what mechanics and auto parts places tell you. They may be trying to be helpful, but they could be wrong. Also check to be sure the level is where it needs to be.
Repair Help & Product Troubleshooting for Volkswagen Golf

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0088 seconds